Eureka 2628819 User guide

TENT- COMBAT ONE PERSON (TCOP) p/n 2628819
pn: 5651826 REV.A 11-05
Set-Up Manual
Content:
Section A - Tent Set Up
Section B - Tent with Fly Set Up
Staking
Limited Warranty
Strike and Erect Log
Parts list: NSN: 8340-01-535-0134
Qty. Part No. Description
1 2628848 Tent
1 5651827 Frame Set
1 2628823 Fly
1 2628847 Tent Bag
1 2628827 Pole Bag
1 2628828 Stake Bag w/Contents
1 2628829 Repair Kit
http://military.eurekatents.com or E-mail [email protected]om

fig 1A
fig 4A
Tent Set Up: Tent, Poles and Stakes
1. Unpack and separate the components. Unfold the tent with the oor
on the ground. Do not stake the tent down yet. However, when windy,
stake down one corner into the wind. See g 1A.
2. Join two shock-corded poles together. Try to prevent pole sections from
snapping together, as this can damage the pole ends. Make certain each
insert (male end) has seated rmly into each plain
end (female).
3. Lay the poles across the tent in an X pattern.
Then insert the post of each pole into a grommet
on the stake out webs. Make sure the side release
buckle on the web points up.
See g 2A and 3A.
Section A
4. At the opposite
end, arch each pole
and seat its post
into the stake out
web grommet to
maintain tension.
See g 4A.
fig 3A
fig 2A

5. Raise both poles over the tent and secure with the toggle and loop
from the top center of the tent. See g 5A.
6. Attach all of the tent clips to the tent poles. See g 6A and 7A.
7. Place the tent in the desired location and
stake it down. Drive the stake through the stake
out web loop only. Do not stake through the
grommet. See g 8A and 9A.
fig 7A
fig 8A
fig 5A fig 6A
fig 9A
The tent is now ready for use

Section B
Tent with Fly Set Up: Tent, Poles, Stakes, Fly and Fly Rod
1. Assemble and stake down the tent as instructed in Section A.
2. Assemble the shock-corded y rod. Try to prevent pole sections from
snapping together, as this can damage the pole ends. Make certain each
insert (male end) has seated rmly into each plain end (female).
3. Slide the y rod through both rod sleeves and the black web loop on
the top of the camo side of the y. Insert the rod end into the grommet
on the web on one end of the y. See g 1B and 2B.
4. At the other end of the y, grasp the web loop and arch the y rod. Seat
the rod post into a grommet on the web. See g 3B.
fig 2B
fig 1B
fig 3B

5. Drape the y over the tent. It’s reversible - use either
camo or tan. Orient the y so that the tent door and
the y door both open from the same end. Align the
rod across the center peak of the tent. See g 4B.
6. Reach under the rain y and secure it to each pole
with the attached Velcro® fasteners. See g 5B.
7. Attach each side
release buckle from the
y to their mates on the
staked out webs. Adjust
web tension as necessary.
See g 6B and 7B.
8 . On the right and left side hem of the y are guy
out loops. Tie the short guy out lines to these loops,
pull taut and stake them down. See g 8B .
fig 4B
fig 5B
fig 8B
fig 7B fig 6B
The tent is now ready for use
Both tent and fly doors
open from here

Engineering Note:
Staking - Extra Guy out Lines and Stakes [not included]
When high winds or storms are predicted, requisition extra guy out
stakes. This model y has built-in loops at optimal guy out locations. It’s
important to put in the extra time guying out your tent. Correctly done, it
can save your tent during heavy weather.
• Attach parachute cord to the loops and stake them in the ground
three or four feet from the edge of the
tent. If staked too close to the tent, the
wind can cause an upward pull and may
dislodge the stakes.
• Make sure that the top y is securely
attached to the framework underneath.
The hook and loop fasteners sewn to the
underside of the y are for this purpose.
Be sure to use them.
• It is a better idea to run two cords at an
angle from the side of the guy out loop.
This will prevent all movement, except
toward the anchor. The guy lines will
now work together through opposition.
See illustrations.
Good: 4 Stakes 4 lines
Better: 4 Stakes 8 lines
LIMITED WARRANTY:
What Is Covered. Eureka! warrants that its products are free from defects
in material and workmanship for two years from the in service date
except as qualied below.
What Is Not Covered. Eureka! shall be not responsible for normal wear
and tear (e.g. exhausted zippers), or defects caused by accident, abuse,
alteration, misuse or improper care.
THERE ARE NO OTHER EXPRESS WARRANTIES BEYOND THE TERMS OF
THIS LIMITED WARRANTY. IN NO EVENT SHALL EUREKA! BE LIABLE FOR
INCIDENTAL OR CONSEQUENTIAL DAMAGES.
What Eureka! Will Do. If, after inspection, we nd that a product failed due
to a manufacturing or material defect, we will repair or replace the
product, at our option, without charge.
How To Obtain Warranty Service. Contact Eureka!'s Customer
Satisfaction Department for return authorization.
Eureka! Customer Satisfaction
P.O. Box 966
Binghamton, NY 13902
800. 572.8822
Collect shipments or shipments without return authorization cannot be
accepted.
How State Law Relates To This Warranty. This warranty gives you specic
legal rights, and you may have other rights which vary from state to
state.
We accept government credit cards (IMPAC), Master Card, or Visa.

Example
Erect Strike
1. Aug. 1, 2006 1. Aug. 7, 2006
2. 2.
3. 3.
ERECT CYCLE STRIKE CYCLE
MISSION LOG
RECORDING ERECT / STRIKE CYCLES IS ESSENTIAL TO DETERMINE THE
INTENDED FIELD LIFE OF THE ITEM. THIS INFORMATION IS CRITICAL IN
HELPING TO RESOLVE CTAP RELATED ISSUES WITH AGED / DAMAGED TENTS

ERECT CYCLE STRIKE CYCLE