7
Clean
Under
Use
Handle
Release
3
HOW TO USE
Theuprightvacuumcleaner designallowsuseon multipletypes
ofcarpeting and on upholstery orbare floors withattachments.
When using the attachment tools, place the handle in the
upright position. Do not place cleaner on furniture or steps
as the brush roll may cause damage.
1. Adjust cleaner height setting knob to lowest position for
maximum cleaning. Adjust to a higher setting to make
pushing easier. For ease in moving the adjustment knob,
place handle in operating position and tilt cleaner back to
remove weight from front wheels.
2. Unwind all of the electrical cord. Located above the cord
hookis the cord retainer. Firmly push the electriccord down
into the cord retainer. Using the cord retainer will keep the
electric cord up, out of the way while vacuuming.
3. Plug electrical cord into outlet.
4. Step on handle release. Pull handle back to a comfortable
position.
5. Push On or Off power switch.
Store or
Use Attachments
4Handle
Release
5ON/OFF
Thermal Cut Off
This cleaner has a special thermostat that protects the
cleaner in case of motor overheating. If the cleaner
suddenly turns off, follow this procedure:
1. Push on/off pedal once.
2. Unplug cleaner.
3. Check for source of overheating problem (i.e. full bag,
clogged hose or clogged filter).
4. If a full bag, clogged hose or clogged filter is found,
replace the bag, unclog the hose or replace the filters.
5. Wait at least 30 minutes before attempting to reuse the
cleaner.
6. After 30 minute cool down period, plug the cleaner in
and push the switch pedal. The cleaner should turn on.
7. Ifthe cleanerstill doesnot operate,take it toany Eureka
Authorized Service Center for repair.
3
2
Cord Retainer
LOW HIGH
1
Cleaner Height Setting
WARNING: Avoid injury. Keep loose clothing, hair,fingers,
and all other parts of body away from any
moving part (such as the revolving brush).
Turn off the switch and unplug the cleaner
before changing the cleaner height setting.
Thefront ofthe cleanerhas anadjustment thatraises orlowers
thecleanerbase to matchthetype ofcarpet.With
the cleaner cord unplugged, set the adjustment
to lowest setting for maximum cleaning. If the
cleaner is difficult to push, move adjustment to
next highest setting until cleaner is comfortable
to push. The brush roll must reach the carpet for
effective cleaning.
NOTE: For ease in moving the adjustment knob, place
handle in operating position and tilt cleaner back
to remove weight from front wheels.
NOTE: When handle is in upright position, brush roll is
lifted off carpet. This is normal. Height adjustment
will not change brush roll level until the cleaner’s
handle is moved into the operating position.
