Euro Appliances ER90UMBG User manual

USAGE AND
CARE GUIDE
PRODUCT
CODE:
ER90UMBG
rangehoods

Content
Safety instructions 3
Installation 5
Start using your cooker hood 7
Troubleshooting 8
Maintenance and cleaning 9
Environment protection 12

3
SAFETY INSTRUCTIONS
This manual explains the proper installation and use of your cooker hood,
please read it carefully before using even if you are familiar with the product.
The manual should be kept in a safe place for future reference.
Never to do:
•Do not try to use the cooker hood
without the grease filters or if the
filters are excessively greasy!
•Do not install above a cooker with
a high level grill.
•Do not leave frying pans unattended
during use because overheated fats
or oils might catch fire.
•Never leave naked flames under the
cooker hood.
•If the cooker hood is damaged, do
not attempt to use.
•Do not flambé under the cooker
hood.
•CAUTION: Accessible parts may
become hot when used with cooking
appliances.
•The minimum distance between the
supporting surface for the cooking
vessels on the hob and the lowest
part of the cooker hood. (When the
cooker hood is located above a gas
appliance, this distance shall be at
least 65 cm)
•The air must not be discharged into
a flue that is used for exhausting
fumes from appliances burning gas
or other fuels. Range hoods and
other cooking fume extractors may
adversely affect the safe operation of
appliances burning gas or other fuels
(including those in other rooms) due
to back flow of combustion gases.
These gases can potentially result in
carbon monoxide poisoning.
After installation, of a range hood or
other cooking fume extractor, the
operation of open flued gas appliances
should be tested by a competent
person to ensure that back flow of
combustion gases does not occur.
Always to do:
•Important! Always switch off the
electricity supply at the mains during
installation and maintenance such as
light bulb replacement.
•The cooker hood must be installed in
accordance with the installation
instructions and all measurements
followed.
•All installation work must be carried out
by a competent person or qualified
electrician.
•Please dispose of the packing material
carefully. Children are vulnerable to it.
•Pay attention to the sharp edges inside
the cooker hood especially during
installation and cleaning.
•Make sure the ducting has no bends
sharper than 90 degrees as this will
reduce the efficiency of the cooker hood.
•Warning: Failure to install the screws or
fixing device in accordance with these
instructions may result in electrical
hazards.
•Warning: Before obtaining access to
terminals, all supply circuits must be
disconnected.

4
Always to do:
•Always put lids on pots and pans
when cooking on a gas cooker.
•When in extraction mode, air in the
room is being removed by the cooker
hood. Please make sure that proper
ventilation measures are being
observed. The cooker hood removes
odours from room but not steam.
•There shall be adequate ventilation of
the room when the cooker hood is
used at the same time as appliances
burning gas or other fuels.
•Cooker hood is for domestic use only.
•If the supply cord is damaged, it
must be replaced by the
manufacturer, its service agent or
similarly qualified persons in order
to avoid a hazard.
•This appliance can be used by
children aged from 8 years and
above and persons with reduced
physical, sensory or mental
capabilities or lack of experience
and knowledge if they have been
given supervision or instruction
concerning use of the appliance in
a safe way and understand the
hazards involved.
•Children shall not play with the
appliance. Cleaning and user
maintenance shall not be made by
children without supervision.
Always to do:
•Caution: The appliance and its
accessible parts can become hot
during operation. Be careful to avoid
touching the heating elements. Children
younger than 8 years old should stay
away unless they are under permanent
supervision.
•There is a fire risk if cleaning is not
carried out in accordance with the
instructions.
•Regulations concerning the discharge
of air have to be fulfilled.
•Clean your appliance periodically by
following the method given in the
chapter MAINTENANCE.
•For safety reason, please use only the
same size of fixing or mounting screw
which are recommended in this
instruction manual.
•Regarding the details about the method
and frequency of cleaning, please refer
to maintenance and cleaning section in
the instruction manual.
•Cleaning and user maintenance shall
not be made by children without
supervision.
•When the cooker hood and appliances
supplied with energy other than
electricity are simultaneously in
operation, the negative pressure in the
room must not exceed 4 Pa (4 x 10-5
bar).
•WARNING: Danger of fire: do not store
items on the cooking surfaces.
•A steam cleaner is not to be used.
•NEVER try to extinguish a fire with
water, but switch off the appliance and
then cover flame e.g. with a lid or a fire
blanket.

5
INSTALLATION (VENT OUTSIDE)
MOUNTING OF THE V-FLAP
If the cooker hood does not have an assembled V-flap 1, you should mount the
half-parts to its body. The images only show an example of how to mount the V-flap,
because the outlet may vary according to different models and configurations.
To mount the V-flap 1 you should:
• Mount two half-parts 2 into the body 6;
• the pin 3 should be top oriented;
• the axis 4 should be inserted into the holes 5 on the body;
• repeat all the operations for the 2nd half-part.
INSTALLATION
1. The cooker hood should be placed at a distance of 65-75cm from the cooking
surface for the best effect.
2. Drill a hole in the cabinet, with hole wide 880*275(mm) for model 90CM.
Refer to pic 1. Make sure the hole edge to the cupboard edge at least 35mm
distance.
3. Put the hood into the cabinet, tighten up the screws by screwdriver, and make sure
the hood was fixed. See pic 2.

6
4. Fix the expansion pipe on the outlet with cable tie. Note: the expansion pipe is not
included in the product. See Pic 3
WARNING: •For safety reason, please use only the same size
of fixing or mounting screws which are
recommended in this instruction manual.
•Failure to install the screws or fixing device in
accordance with these instructions may result in
electrical hazards.

7
Start Using Your Cooker Hood
LED touch control
LED touch control has five buttons, see picture.
(Decrease), (Increase), (Lamp), (Timer), (Power)
1. Power-on: After connecting the cooker hood to the main supply, the backlight of
button will turn on, output will be closed and the cooker hood will enter into stand-
by mode.
2. (Power) button:
2.1. Press (Power) button, the backlight of button will be on and the hood will work
at the low speed, and the light will be on. The backlight of the buttons (Decrease),
(Increase), (Lamp), and (Power) will be on. Press (Power) button
again, the backlight of button will be off and the cooker hood will be turn off and return
into stand-by mode and operate by the circle.
2.2. The button of (Lamp) button could be operated without pressing the
(Power) button. Press (Power) button, the cooker hood will be turn off without any
functions.
3. (Lamp) button:
Press (Lamp) button, the backlight of button and the lights will be on. Press again,
the lights will be off. The lights run circularly.
4. (Increase) button:
4.1 Press (Increase) button, the backlight of button will be on, the cooker hood
starts to work at the low speed. the LED display will display “1”,
4.2 Press (Increase) button again when it is working on the low speed, the cooker
hood works at the mid speed and the LED display will display “2”,
4.3 Press (Increase) button again when it is working on the mid speed, the
cooker hood works at the high speed and the LED display will display “3”.

8
5. ( Decrease) button
Press (Decrease) button, the cooker hood will decrease one speed, and the
display will show the current working speed. When press (Decrease) button again
when it is working on the low speed, the cooker hood will turn off and the backlight of
the (Decrease) button will be off.
6. (Timer) button:
6.1 The (Timer) button works when the motor and light is on only. The timer
setting is 5mins and could be repeat setting. When the time is up, the cooker hood will
be turn off and the light will be off.
6.2 When the timer is set, if adjusting the speeds, the timer will re-calculate the
working time.
TROUBLESHOOTING
Fault Possible Cause Solution
Light on, but motor
does not work
Fan switch turned off Select a fan switch position.
Fan switch failed Contact service center.
Motor failed Contact service center.
Light does not
work, motor does
not work
House fuses blown Reset/Replace fuses.
Mains power cable is loose or
disconnected
Refit mains power cable to
power outlet.
Switch power outlet on.
Oil leakage
One way valve and the outlet
are not tightly sealed
Take down the one way valve
and seal with sealant.
Leakage from the connection of
chimney and cover Take chimney down and seal.
Lights not working Broken or faulty bulbs Replace bulbs as per this
instruction.
Insufficient suction
The distance between the
cooker hood and the gas top is
too far
Refit the cooker hood to the
correct distance.
The Cooker hood
inclines
The fixing screw is not tight
enough
Tighten the hanging screw and
make it horizontal.
NOTE:
Any electrical repairs to this appliance must conform to your local, state and
federal laws. Please contact the service centre if in any doubt before undertaking
any of the above. Always disconnect the unit from the power source when
opening the unit.

9
MAINTENANCE AND CLEANING
Caution:
• Before maintenance or cleaning is carried out, the
cooker hood should be disconnected from the mains
power supply. Ensure that the cooker hood is switched
off at the wall socket and the plug removed.
•External surfaces are susceptible to scratches and abrasions, so please follow the
cleaning instructions to ensure the best possible result is achieved without damage.
GENERAL
Cleaning and maintenance should be carried out with the appliance cold especially
when cleaning. Avoid leaving alkaline or acid substances (lemon juice, vinegar etc.) on
the surfaces.
STAINLESS STEEL
The stainless steel must be cleaned regularly (e.g.weekly) to ensure a long life
expectancy. Dry with a clean soft cloth. A specialized stainless steel cleaning fluid may
be used.
NOTE:
Ensure that wiping is done along with the grain of the stainless steel to prevent any
unsightly crisscross scratching patterns from appearing.
CONTROL PANEL SURFACE
The inlay control panel can be cleaned using warm soapy water. Ensure the cloth is
clean and well wrung before cleaning. Use a dry soft cloth to remove any excess
moisture left after cleaning.
Important
Using neutral detergents and avoid using harsh cleaning chemicals, strong household
detergents or products containing abrasives, as this will affect the appearance of the
appliance and potentially remove any printing of artwork on the control panel and will
void manufactures warrantee.
GREASE MESH FILTERS
The mesh filters can be cleaned by hand. Soak them for about 3 minutes in water with
a mild detergent and then brush it gently with a soft brush. Do not apply too much
pressure so as to avoid any damage to it. (Leave to dry naturally out of direct sun light)
Filters should be washed separately to crockery and kitchen utensils. It is advisable
not to use rinse aid.

10
INSTALLING GREASE MESH FILTERS
To install filters for the following four steps:
•Angle the filter into the slots at the back of the hood
•Push the button on the handle of the filter
•Release the handle once the filter fits into a resting position
•Repeat to install all filters
CARBON FILTER-not supplied
Activated carbon filter can be used to trap odors. Normally the activated carbon filter
should be changed every 3 to 6 months according to your cooking habits. The
installation procedure of activated carbon filter is as below:
1. Before installing or replacing the carbon filters, please remove power to the unit.
2. Press the filter lock and remove the mesh filter.
3. Turn the carbon filter on both side of the motor anti-clockwise. Replace the carbon
filters with the new carbon filters.
4. Place the mesh filter.
5. Connect the power supply to the wall socket.
NOTE:
•Make sure the filter is securely locked. Otherwise, it would loosen and cause
danger.
•When activated carbon filter attached, the suction power will be lowered.

11
BULB REPLACEMENT
Important
•Always switch off the electricity supply before
carrying out any operations on the appliance. When
handling bulb, make sure it has completely cooled down
before any direct contact with hands.
•When handling bulbs hold with a cloth or gloves to ensure
perspiration does not come in contact with the bulb as this
can reduce the life of the bulb.
Note:
•Before changing the lights, make sure that the appliance is turned off and
unplugged.
•Protect against danger when changing lights, such as wearing gloves.
Changing the lights:
1. Switch off the appliance and unplug it.
2. Unscrew the 4 screws on the outer glass frame panel by screwdriver.
3. Pull out the light wire and switch wire, take down the outer glass frame panel.
4. Unscrew the screws on the light bracket and replace the lights.
5. Apply the reverse procedure to install the light back.
•ILCOS D code for this lamp is: DSS-1.5/65-S-120/33
•LED modules –rectangle lamp
•Max wattage: 2×1.5W
•Voltage range: DC 12V
•Dimensions:

12
ENVIRONMENTAL PROTECTION
This product is marked with the symbol on the selective sorting of
waste electronic equipment. This means that this product must not
be disposed of with household waste but must be supported by a
system of selective collection in accordance with Directive
2012/19/EU. It will then be recycled or dismantled to minimize
impacts on the environment, electrical and electronic products are
potentially dangerous for the environment and human health due to
the presence of hazardous substances.For more information, please
contact your local or regional authorities.
NOTE:
The following shows how to reduce total environmental impact (e.g. energy use)
of the cooking process).
(1) Install the cooker hood in a proper place where there is efficient ventilation.
(2) Clean the cooker hood regularly so as not to block the airway.
(3) Remember to switch off the cooker hood light after cooking.
(4) Remember to switch off the cooker hood after cooking.
INFORMATION FOR DISMANTLING
Do not dismantle the appliance in a way which is not shown in the user manual.
The appliance could not be dismantled by user. At the end of life, the appliance
should not be disposed of with household waste. Check with your Local Authority
or retainer for recycling advice.

Pronto Service + Support: 1800 440 335
Email: [email protected]
HEAD OFFICE
65 Glynburn Road, Glynde SA 5070
Ph: 08 8165 1012
www.euroappliances.com.au