
• Fitting: Plastic
• Class: Class 2
• IP Rating: IP 20
• Voltage: 220V - 240V ~ 50Hz
• Dimensions: (Ø)66.3mm x (L)228.5mm
• Lamp Type: Integrated 5W LED 220 - 240V
• Battery: 3.7V 1500mah sealed Lithium-ion rechargeable battery
• Battery Charge time: 20 - 24 Hours
• Battery Life: 2 - 4 Hours (Torch) | 1.5 - 2 Hours (Dim setting)
• The light source of this luminaire is not replaceable. When the light source reaches its end of life the
whole luminaire should be replaced, or the light source should only be replaced by the manufacturer.
SPECIFICATIONS
HOW TO OPERATE
1 This product is designed as a mechanical push switch. Face up, from left to right, the switch mode
corresponding to the switch gear: II (lLantern) - OFF - I(spotlight)
2 The Lantern can be used as an emergency light.
3 This product plug can rotate 90°(horizontal insertion and vertical insertion into wall outlet). If you need
to insert it vertically, you can rotate it by 90°.
4 Theplugpositionofthisproducthasroundinsertandatinsert,whichcanbeselectedaccordingto
requirements.
5 Use AC 220V to charge the product. The charging time is recommended to be around 20 - 24 Hours.
6 The red light is the charging indicator, and the red indicator light is on when charging.
7 Whentheproductischarging,theswitchshouldbeturnedoaslittleaspossibletohelpprotect
the battery.
8 When the product is not used frequently, it is recommended to charge and discharge every three
months to ensure the battery life.
FS275 - attachments:
Iftheexternalexiblecableorcordofthisluminaireisdamaged,itshouldbeexclusivelyreplacedby
themanufacturerorhisserviceagentorasimilarqualiedpersoninordertoavoidahazard.
To ensure that you get maximum longevity and maximum use out of your luminaire, please
observe the following safety instructions.
Electrical products can cause death, injury, or damage to property. Installation of the luminaire must
becarriedoutbyaqualiedelectrician,inaccordancewithSANS10142.Oncompletionof
installation,ensurethattheCerticateofComplianceisupdated.
• Before connecting this luminaire, ensure that voltage indicated on the rating label corresponds with the
mains voltage in your home.
• Whenchangingthelamp,ensurethatthepoweristurnedo.
• This luminaire is checked in full for conformity to the quality standards and safety requirements.
• The manufacturer / supplier is not responsible for any damage of properties and persons, caused by
the incorrect use or installation of the luminaire.
• Should you be unsure of how to install this luminaire correctly, please consult a professional electrician
or your supplier for assistance.
• Ensure all items/ components, threads and screws are tightly secured.
IMPORTANT:
• Tampering with this luminaire, i.e.using silicon sealers or incorrect cabling, will invalidate
your warranty.
• When the protection glass is damaged, it should be replaced immediately. The luminaire
must not be used without the protection glass.
• Please check whether the connection of the power cord is safe and reliable before installation.
• Always ensure that the mains supply voltage is correct.
• Always replace the lamp with one of an identical rating.
• Ensure that you do not place the luminaire near any combustible materials and / or surfaces.
• Choking hazard: May contain small parts. Keep away from children.
• Donotinsertyourngersoranypartofyourbodyintotheelectricalcontactandsocketsofthisproduct
whilst it is connected to the electricity supply.
• Item may vary slightly from the picture on the carton.
• Coastalhumiditymayeectthelongevityoftheluminaire.
• Outdoor luminaires must be cleaned to prevent rust occurring.
• Use a copper grease on all screws or strings.
IMPORTANT SAFEGUARDS