Evelo DPC-18 User manual

DPC-18 Display
OWNER’S MANUAL
Our Team is here to help 7 days a week
[e-mail] |877-991-7272
Feel free to reach out!
EVELO.COM

2
DPC-18 DISPLAY
Display and Keypad
Time
Speed
Tripometer
Odometer
Max Speed
Average Speed
Range
Calories (not used)
Trip Time
USB Port in Use Light Indicator
Battery Voltage or
Battery Percentage
Current Power Usage
Pedal Assist Level

3
DPC-18 DISPLAY
Using Your Bike
Powering the Bike ON/OFF
Hold the ON/OFF button to power on the bike. Hold down the ON/OFF
button for three seconds to turn the bike off.
Speedometer
The speed is shown in the middle of the screen. You can choose miles or
kilometers in the settings menu.
Pedal Assist Level Selection
Press the + or - button to select your pedal assist level. You can choose
from 0 to 5, with 0 being no assistance and 5 the most assistance.
Light Usage
Your bike has an ambient light sensor and will automatically turn the lights
on and off. If you wish to turn them on manually, hold the Light button for
2 – 3 seconds; hold it again to turn them off.
Battery Indicator
The battery’s state of charge is shown as a bar and as a percentage by
default. You can also change it to read actual voltage in the Settings
Menu. When the outside edge of the battery frame flashes it indicates
that the battery is severely low and needs to be recharged immediately.
Error Code Indicator
If there is something wrong with the electronic control system, the error
code and error message will display in the top of screen. If you get an
error code, contact us for information.

4
DPC-18 DISPLAY
Settings Menu
Double tap the Mode button quickly to enter the Settings menu, click + or - to
select the item, then click MODE again. Then you can press + or - to select the desired
parameter, and aer the parameters have been changed, click Mode again. You can
change the following settings:
Units
You can choose between metric and imperial units.
Brightness
Set the brightness of the display as a percentage.
Auto OFF
Your bike will turn off aer a period of inactivity. Set
the length of that period here from 1 to 9 minutes.
Max PAS
Set the number of Pedal Assist levels, either 3, 5, or
9. The number of levels you choose doesn’t affect
the peak power output. The higher number of levels,
the smaller the difference between each will be.
Power View
Power can be displayed either as Watts (power) or
Amps (current).
SOC View
Shows the battery level as either voltage or percent.
TRIP Reset
Choose Y to reset the trip odometer.

5
DPC-18 DISPLAY
Settings Menu
Wheel
Set your wheel size. It is set correctly from the factory. You can reference the
tire size printed on the tire or contact us for more information if needed.
Speed Unit
The max speed is 20 mph by default. When you reach the specified
speed, assistance will be turned off. The limit can be raised, but you
should check your local laws before doing so.
AL Sensitivity
Your bike automatically turns on the lights. Adjust the sensitivity of that
feature here.
Password
You can set a password to use the bike and to access the settings. The
default password is 1919. If you change the password and forget it, we
cannot unlock it; the display will have to be replaced.
Set Clock
Set the time on the display’s clock.
Battery Info
This menu isn’t used.
Error Code
Any error codes are stored here, even aer they go away on the main
screen.
Auto Sleep Aer 5 Minutes
When the bike does not move for 5 minutes, the system will power down
automatically.

6
DPC-18 DISPLAY
Notes:

7
DPC-18 DISPLAY
Notes:

8
DPC-18 DISPLAY
Questions? Get In Touch:
EVELO.COM
First Edition
877-991-7272
[e-mail]