Evinox ModuSat UA10 User manual

1
Key to Symbols
The following symbols for the operating modes are
shown to the left hand side of the screen on the Room
Controller -
Description of Operating Modes
Comfort (ON)
Comfort mode should be set to the temperature required
when the home is occupied. (Recommended
temperature setting is 21°C)
Reduced (OFF)
Reduced mode should be set to the minimum
temperature required when the home is not occupied.
(Off) (Recommended temperature setting is 15°C)
Anti-freeze
Anti-freeze is factory set at 10°C. This mode should be
selected to provide frost protection when the property is
unoccupied for long periods. (Note: Anti-freeze disables
the heating mode unless the temperature falls below the
set 10°C)
Summer (Summer mode only applicable to cooling models)
When Summer mode is selected the heating is disabled
with hot water provision only.
Winter
When Winter mode is selected both heating and hot
water provision is available.
Room Controller User Guide
You can nd information over the following pages about how to operate the ModuSat Room Controller in your home.
- Comfort
- Reduced
- Summer
- Winter
Use button “F” (Function) to change the
operating mode. (Summer / Winter mode is only
applicable to cooling models).
Evinox Ltd T. [phone] E. [e-mail] W. www.evinox.co.uk
2551127J
ModuSat
Room Controller
ModuSat Room Controller
Target
Temperature
Current
Ambient
Temperature
Comfort
Reduced
Summer
(only applicable
to cooling models)
Winter
Heating
Hot Water
Function
Humidity
(Cooling model only)
The blue line indicates which programme mode(s) is selected.

2
Parameter Setting
This operation allows the user to set the temperature set point for comfort, reduced, anti-freeze and HW, that will
follow the daily or weekly set time schedule.
Time Schedule Programming
The time schedule can be set to control the comfort, reduced or antifreeze operation of the system.
ModuSat
Room Controller
The temperature set point can be changed using the ‘+’ or ‘-‘ buttons. The set temperature can be changed within
+/- 3 °C.
Please Note: You must select the operating mode, as shown over the page, to activate the time schedule programme.
(For example, if you have selected a weekly programme you must select the “Weekly” mode in the “Set Mode” screen)
Weekly

3
Operating Mode Selection
This operation allows the user to set the operating mode: comfort, reduced, daily, weekly, anti-freeze, clock date and
time. (DHW= Domestic Hot Water)
Reading Your Consumption Figures
The user can read the consumption gures for the unit, for example: C for heating, C1 cooling (when present) and C2
cold water (Only when a cold water meter is installed within the dwelling and connected to the Evinox system) The
display also shows the temperature and ow rate related to the three counters.
Denition of Card Consumption Figures:
Credit: The remaining energy credit
Extra Used: The amount of emergency credit that has been used
Extra Max: The max amount of emergency credit available
Heating Cost: The cost of each energy unit (per kwh)
Screen 3 & 4 below are only accessible when the PaySmart prepayment unit is tted.