6
www.evolutionpowertools.com
• Do not use if the stand becomes damaged
in any way.
The main frame can support 150kg (330lb)
total weight (saw + material).
Do not exceed this weight for any reason.
STAND FEATURES
• Lightweight tubular frame with ø45mm
tubular legs and crossbars.
• Extension rails adjustable to give roller
support centres from 860mm (min) to
1620mm (max).
• Mounts most mitre saws.
• Height to saw mounting base 750mm
• Height adjustable work support extensions,
support work pieces on 230mm long rollers
which are equipped with repeat cutting stops.
DEPLOYING THE LEGS
PRIOR TO ASSEMBLY
Note: It is much easier to set up or knock down
the stand without a saw being attached.
• Push the locking/unlocking button
(Fig. 1) and deploy all 4 legs, ensuring they
are locked in their service position.
ASSEMBLY INSTRUCTIONS
• Screw the long locking screws (D) into
the guides. (Fig. 2)
• Slide the work support brackets (C) onto the
extension arms and lock in place with a long
locking screw (D). (Fig. 3)
• Insert the work support roller (B) into the
bracket and lock in place using a long
locking screw. (D) (Fig. 4)
For Normal Cutting Operations:
• The top of the roller(s) should be level with
the surface of the Mitre Saws rotary table.
• The extension arm(s) should be
positioned be give maximum support
to the workpiece.
For Repetitive Cutting Operations:
• The ‘stop face’ (Fig. 4a) can be positioned at
the required distance from the saw blade.
• The required work support should be
adjusted so that the ‘stop shelf’ (Fig. 4b)
is level with the Mitre Saws rotary table and
facing towards the saw.
• Adjust the relevant extension arm until the
‘stop face’ is at the required distance.
CHECKING AND ADJUSTING
THE SAW MOUNTING BRACKET
CLAMPING PRESSURE
The pressure exerted by the clamping
mechanism within a saw mounting bracket
can be adjusted. The clamping pressure of
each bracket should be checked before it is
attached to a mitre saw. When tted across
the mitre saw stands two main crossbars, and
with the locking handle in the down (locked)
position, a bracket should be rm and exhibit
no signs movement.
Excessive force to deploy the locking lever
to the down position should be avoided.
Gently pressing the lever downwards with the
palm of a hand should be all the force
needed to operate the locking lever.
To adjust the clamping pressure:
• Turn the clamp upside down to reveal
the mechanism.
• Loosen the locking nut. (Fig. 5)
• Turn the adjustment screw (Fig. 6)
clockwise to increase the clamping
pressure. Turn the screw counter-clockwise
to decrease the clamping pressure.
• Tighten the locknut when adjustment is
successfully completed.
MOUNTING EVOLUTION MITRE
SAW TO THE MITRE STAND
Note: The Evolution Mitre Saw Stand is
suitable for most Evolution Mitre Saws.
• Remove and safely store the four (4)
plastic feet from underneath the base of
the mitre saw. (Fig. 7)
• Remove and safely store the stability
block from underneath the positive stop
locking lever. (Fig. 8)
