Explore Scientific 0690600 User manual

TWO ROOM POP-UP OBSERVATORY TENT
ART. NO. 0690600
INSTRUCTION MANUAL
WARNING: KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS TENT FABRIC.
This tent made of flame-resistant fabric which meets CPAI-84 specifications. IT IS NOT FIRE-PROOF ! The fabric will
burn if left in continuous contact with any flame source. The application of any foreign substance to the product fabric
may render the flame-resistant properties ineffective.
•DO NOT use fuel burning devices inside or near tent materials.
•DO NOT permit children to light matches, operate burnng appliances, or handle any flame sources in or near the tent.
•DO NOT smoke, use matches, candles or open flames of any kind in or near the tent.
•DO NOT refuel lanterns, stoves or heaters inside or near the tent.
•DO NOT cook inside or near the tent.
•DO NOT store flammable liquids inside or near the tent.

WHAT’S IN THE BOX?
BASE TENT
CA. 152X152 CM
60" X 60”
STEP 1: Grap the tent and the extension tent.
Carefully expand and set aside.
STEP 2: Stand the base tent upright,
open and pull from the center to
form the structure.
NOTE: Some twisting of the steel loops might be
necessary to form the correct shape.
STEP 3: Open both entraces and roll the door
flaps. Use the attached straps to tie the
flaps.
CAUTION: This structure uses a spring steel loop that will pop open quickly!
EXTENSION
TENT
TOP COVER
CA. 304X304 CM
120” X 120”
12 PARACORDS
WITH CORD LOCKS
12 GROUND STAKES
ca. 182 cm (6 ft.)
2
1
BEFORE YOU START
Read all instructions carefully before beginning set up.
· Select a level site clear of rocks, branches, and other
hard or sharp objects, to set up your tent.
· Do not set up your tent under trees because of
potential lightning strikes or falling tree limbs in
inclement weather.
SCAN THE QR CODE TO VISIT OUR
“HOW TO SET UP” VIDEO*.
* Video in English. You will be redirected to a YouTube channel to view the video.
1
2

STEP 4: Stand the extension tent upright, open each side and locate the
hook and loop fasteners.
STEP 6: Attach the extension tent to the base tent
with the hook and loop fasteners.
Optional: For a more secure structure, slide stakes
through each bottom loop corner and
hammer into the ground.
STEP 9: Use the top cover to temporary protection when not in
use. Follow Steps 7 and 8 to secure the top cover.
NOTE: Use the same stakes from Step 8 to attach the paracords.
Top cover should be loose and not taut to keep the
structure up.
STEP 7: Take the paracords and insert one on
each top corner loop of the tents. Make
a knot of your choice to secure.
STEP 8: Hammer stakes into the ground so
that you can extend the paracords
out at 45° angle from the tent.
Tighten the paracords as needed
by adjusting the slider up the cord.
NOTE: Tents should be taut when staked
properly.
STEP 5: Locate the hook and loop fasteners on the base
tent.
Hook & Loop
Fastener
Hook & Loop Fastener
Hook & Loop Fastener
Slider
x6

1
2
180°
1
2
Start with the base tent, push one corner into the
opposite corner and fold down the center flat.
Rotate the tent by 180° and hold as shown with the
peak pointing away from you.
Slide the top corner to the left.
Extension tent, fold each side panel to the inside flat.
Take one corner and connect it to the opposite corner.
Fold in the circles that are formed on each side.
BRESSER GmbH · Gutenbergstr. 2 · DE - 46414 Rhede · Germany
HOW TO FOLD AWAY