page-4
ez-liner pro series 1300 paint striper - operating manual
page-4
This airless equipment uses high pressure. Leaks from components or ruptured hoses can inject
fluid through the skin and into the body. Injection of paint or other fluids such as hydraulic oil into
the body can result in injury and could result in amputation of the affected area. Injection in the
skin is a serious traumatic injury. It is important to treat the injury as soon as possible.
Always make a visual inspection of all fittings and hoses prior to operating. Replace any worn or defective
5.
hoses immediately and tighten any loose connections. Never try to repair high pressure hoses or fittings.
Never try to stop or deflect leaks with your hand or body. Never plug a hose leak with your finger, with
6.
adhesive tape or other “stop gap”device.
Quote from the National Safety Council. “The complete observance of one simple rule would prevent
7.
many thousands of serious injuries each year.”
That rule is: Never attempt to clean, oil, troubleshoot or adjust machine while in use!
Operate the unit only in a well ventilated area.
8.
Turn the gas valve off at the engine during transit.9.
SAFETY EQUIPMENT
1. High pressure units must be grounded to prevent dangerous static sparking. Never operate this unit1.
without the ground chain or strap in place.
If you experience any static sparking or any slight shock while using this equipment, stop spraying
2.
immediately. Sparks can ignite fumes from solvents and the fluid being sprayed, dust particles and other
flammable substances, and can cause a fire or explosion and serious bodily injury and property damage.
Check the entire system for proper grounding. Do not use the system again until the problem is identified
and corrected.
A good practice is to have a dry chemical fire extinguisher nearby while operating this machine. Be familiar
3.
with its operation and keep it properly charged.
This unit should never be operated without guards or shields in place.
4.
It is recommended that safety glasses be worn when operating, and maintaining this unit. Loose clothing5.
should not be worn when working around moving parts.
Hearing protection is recommended during operation of this unit.
6.
This unit is equipped with two safety air relief valves: one on the air compressor manifold and one on the7.
bead tank. This unit must never be operated without them in place and in good operating condition. It is
important to keep them clean and in good working order.
