EZANDA 14166 User manual

Single Hole
Application
3-Hole
Application
· Every once in a while, please rinse the faucet with lukewarm soapwater, and wipe it clean with a soft duster cloth.
Please avoid any abrasive cleaners, steel wools, or corrosive chemicals.
1.Install square Gasket ②onto Faucet Body ①.
Slide single hole faucet through the sink mounting hole.
7
1
6
5
4
3
2
6
5
4
3
2
8
9
8
9
Note: Escutcheon is included for 3-Hole applications.⑦
2.Place Stainless Steel Washer ④and Rubber
Washer ③onto Mounting Studs ⑥under the
sink, and tighten the Mounting Nuts ⑤securely
as shown.
3.Connect and screw on the Supply Hoses ⑧toValves ⑨.
4.Turn on faucet to check for leaks.
· To insure proper installation, please read the following instructions carefully.
· Please make sure that the water supply has been shut off at the stop valve.
· EZANDA reserves the right to update product without notice.
BEFORE INSTALLATION If you have any question or need help,
please visit website
http://www.ezanda.com

1Unscrew components
Pop-up Drain with Overflow Installation Guide
NOTES:
A & B to the seal.
4Connect the rear end of the drain to the Drain Pipe.
2 Slide the drain body C through the hole
C:the drain body
in the sink.
5Push to activate. 3Screw components A & B back on as shown.
A
B
A
B
Fits for sink WITH overflow
hole.
Clean the sink hole, make
sure to remove debris.
Please avoid using
plumber's putty.
The seal on top is
leak-free.
Plumber's putty might
cause damage.
Silicone and plumbing tape
can be use for sealing
requirement.
If you have any question or need help, please visit website http://www.ezanda.com