factoryfurniture.co.uk
Introduction
Design
Design, shop drawings and development by
Factory Furniture Ltd.
Manufacture
Factory Furniture manufactured components. Products
are assembled in Factory workshops, checked and
dispatched ready for installation. Replacement products
or components thereof should be ordered direct from
Factory Furniture Ltd.
Copyright
The design copyright for the product and drawing
copyright remains the sole property of Factory Furniture
Ltd.
General Specifications
MURTON Cycle Stand
Metric L 425mm | W 60mm | H 800mm *
Imperial length 1’ 4½” | width 2½” | height 2’ 7½” *
* Not incl. +250mm (10“) below ground level for sub-surface root fix
Approx Weight 17kg
Fixing method 190mm (7½”)
Detailed Material & Finish
Specifications
Frame
• Manufactured from mild steel with a hot dip
galvanised finish. (Option for polyester powder
coated finish available on request (any RAL colour).
• Root fixed 250mm (10”) below ground level
General Maintenance
(Recommended Schedule & Guidelines)
Daily/Weekly/Monthly (or as adopted)
Visual checks of post, fingers and lettering - check all
items for superficial or physical damage
Three Monthly
Clean all items as detailed below check all fixings are
seated correctly
Six Monthly
Secure all fixings; full clean as detailed below; check
that product is firmly secured to the ground
Specific Maintenance Details
Galvanised & Polyester Powder Coated Surfaces
For general cleaning using a damp cloth and warm
soapy water only. Scourers and abrasive cleaners are
NOT suitable for this type of finish and may damage it.
Before using any cleaning agents to remove grati etc.
try on a small, inconspicuous area first to avoid causing
more unsightly damage
Repairs
Galvanised Surfaces
For light damage to hot dipped galvanised finishes
repair using a high performance cold galvanising zinc
spray (70% zinc or above). Spray application should
be carried out in accordance with approved methods
detailed by the product manufacturer. Please note that
it is advisable to use professional painters to achieve
best results when touching up larger areas.
Polyester Powder Coated Surfaces
For light damage (scratches, chips etc.) repair using
touch-up paint to match original colour (available
from Factory Furniture Ltd). Paint application should
be carried out in accordance with approved methods
detailed by the paint manufacturer. Please note that
it is advisable to use professional painters to achieve
best results when touching up larger areas. Products
for respraying larger areas are available from Factory
Furniture Ltd.
Heavy Damage
In the event of serious damage to any component,
replacements should be ordered from Factory Furniture
Ltd. In this event (or if the product needs to be
disassembled for any reason), please contact Factory
Furniture for detailed technical advice.
