&
5HVSRQVLEOH
)RUHVW0DQDJHPHQW
Introduction
Design
Design, shop drawings and development by Factory Furniture Ltd.
Manufacture
Factory Furniture manufactured components. Products are assembled in Factory workshops, checked and
dispatched ready for installation. Replacement products or components thereof should be ordered direct from
Factory Furniture Ltd.
Copyright
The design copyright for the product and drawing copyright remains the sole property of Factory Furniture Ltd.
General Specifications
QUAY Cycle Stand A
Metric L 335mm | W 80mm | H 725mm *
Imperial length 1’ 1” | width 3” | height 2’ 4½” *
* Not incl. +200mm (8“) below ground level for sub-surface fix
Approx Weight 13kg
QUAY Bollard
Metric L 140mm | W 100mm | H 740mm *
Imperial length 5½” | width 4” | height 2’ 5” *
* Not including +200mm (8”) below ground level for sub-surface fix
Approx Weight 16kg
Detailed Material & Finish Specifications
Timber Slat(s)
• Manufactured from FSC®certified timber.
• Slats are profiled and left untreated as standard.
• Fixed to galvanised mild steel frame.
Frame
• Manufactured from mild steel with a hot dip galvanised finish. (Option for polyester powder coated finish
available on request (any RAL colour).
• Root fixed 200mm (8”) below ground level
General Maintenance (Recommended Schedule & Guidelines)
Daily/Weekly/Monthly (or as adopted)
Visual checks of timber slat(s) and frame - check all items for superficial or physical damage.
Three Monthly
Clean all items as detailed below check all fixings are seated correctly; inspect timber for serious damage and
splinters.
Six Monthly
Secure all fixings; full clean as detailed below; check that product is firmly secured to the ground
Specific Maintenance Details
FSC Timber
Clean with a stiff brush once per year, especially in more exposed locations, in order to prevent a verdigris type
build up on the timber surface. Ideally this should be completed in early spring. During the cleaning stage, all
exposed timber surfaces should be inspected for splits and splinters. Any splinters and graffiti should be
removed and the surface sanded with 100 grit sandpaper in order to remove any uneven / sharp edges or
surfaces.
Galvanised & Polyester Powder Coated Surfaces
For general cleaning using a damp cloth and warm soapy water only. Scourers and abrasive cleaners are NOT
suitable for this type of finish and may damage it. Before using any cleaning agents to remove graffiti etc. try
on a small, inconspicuous area first to avoid causing more unsightly damage.
2QUAY CYCLE STANDS specification
QUAY Cycle Stand B
Metric L 480mm | W 80mm | H 725mm *
Imperial length 1’ 7” | width 3” | height 2’ 4½” *
* Not incl. +200mm (8”) below ground level for sub-surface fix
Approx Weight 14kg
