FAIR BIO80 User manual

FAIR srl - Via Lago di Costanza 24 - 36015 Schio - Vicenza - Italia - [phone] - [e-mail] - www.fair-europe.com
Pag. 1
Cleaning pellet stoves models
BIO80/H - BIO100/H
Reserved for specialized personnel

FAIR srl - Via Lago di Costanza 24 - 36015 Schio - Vicenza - Italia - [phone] - [e-mail] - www.fair-europe.com
Pag. 2
1. Turn on the stove for about 15 minutes to warm all of its parts.
2. Turn off the stove and wait for the shut-off phase to be completed before starting the disassembly.
3. Disconnect the power supply.
4. You must have the following materials before handling the stove:
Anti-scratch protection gloves
Powder mask
Ash aspirator, brush, screwdriver, rubber hammer, hex key and spatula
Any gaskets and replacement tubes
High temperature silicone 750°C or higher
5. Check the chimney, clean the T-fitting (if present),
inspect the entire section of the tube connecting
the stove to the chimney and the chimney itself.
6. Check if gaskets and any fittings / tubes are intact.
If damaged replace them.
7. Remove the top of the stove by unscrewing the 3
screws holding it secured, using hexagonal
wrench.

FAIR srl - Via Lago di Costanza 24 - 36015 Schio - Vicenza - Italia - [phone] - [e-mail] - www.fair-europe.com
Pag. 3
8. Remove the heat exchanger grille by unscrewing
the 4 star screws.
9. Remove the right and left fluegas inspection plates
by unscrewing hexagonal screws with hexagonal
or tube wrenches. Use a screwdriver, if necessary,
to remove the siliconized dowels.
10. To remove soot and scratches beat in the front
and top area with a rubber hammer or similar as
shown in the picture.
11. Insert a pipe cleaner inside of inspections to
precipitate the soot adhered to the smoke motor.
12. Use the ash aspirator with the 2 open inspection
doors.

FAIR srl - Via Lago di Costanza 24 - 36015 Schio - Vicenza - Italia - [phone] - [e-mail] - www.fair-europe.com
Pag. 4
13. Remove the brazier and ash drawer from their
housings, empty them and clean them properly.
14. Pull the plate below the ash drawer, tilt it and
rotate it, this will allow you to access the smoke
motor compartment.
15. Aspirate the brazier compartment and the engine
compartment under the ash drawer, releasing
them from all the soot present. Be careful not to
bend the fan, it may compromise the functioning
of the stove.
16. Vacuum the dust and clean the surface where the inspection is under the ash drawer, check the
overall condition and then close it all.
17. Before assembling, check the integrity of the brazier and drawer and make sure that they are
properly cleaned for proper operation of the stove.
18. Reinstall the inspection plates by carefully cleaning the base and securely tightening the retaining
screws.

FAIR srl - Via Lago di Costanza 24 - 36015 Schio - Vicenza - Italia - [phone] - [e-mail] - www.fair-europe.com
Pag. 5
19. Finish maintenance with an external cleaning of the stove, using an anti-static cloth to avoid
damaging the paint.
20. Turn on the stove to check its proper functioning.
21. For any information contact the FAIR Technical Department at [phone].
NB: We recommend that the chimney is checked and inspected by a specialized company to ascertain
the good condition of the chimney.