Fantech FSW154 User manual

Part No. INST- FSW 08/12 Page 1 of 3
FSW154 - Filtered Supply Air
Wall Unit
CONTENTS & INSTALLATION INSTRUCTIONS
Contents:
EIE150 Fan 1 off.
PureV G4 Panel Filter (495x495x45) 1 off.
Powder coated Steel Filter Box 1 off.
Installation Instruction 1 off.
Installation:
1. Installation of this product should be carried out by appropriately qualified persons.
2. Ensure the unit has arrived in good condition and that the impeller is free to rotate.
3. Cut a hole in the wall to the square spigot dimensions (240mm Width X 265mm Height).
4. Remove the backing plate from the filter box by undoing the 13 screws.
5. Install the filter box on the outside wall by inserting the square spigot into the cut out hole,
then drilling and screwing the filter box onto the wall. Ensure that the filter box grille is at
the bottom.
6. Remove the grille from the EIE150 Fan and insert fan on the inside wall. Mount fan with
through the holes provided. Reinstall the grille.

Part No. INST- FSW 08/12 Page 2 of 3
7. From the outside wall, plug the EIE150 Fan into the socket inside the filter box.
8. Install the filter ensuring the filter lines run vertically and twist the P-clips 90 degrees to lock
it in place.
9. Reinstall the backing plate.
10. Plug external filter box lead into 240V AC power point.
Safety Considerations:
1. All connectionsmust be in accordance with any local regulations.
2. The Licensed Electrical installer must ensure that an approved means of disconnection be incorporated into the fixed
wiring.
3. This fan hasan automatic thermal cut-out switch incorporated in themotor as standard.
4. This productis not intendedfor use by persons (including children) with reduced sensory ormental capabilities, or lack
of experience and knowledge, unless they have been given supervisionor instructionconcerning use of the product by a
person responsible for their safety. Childrenshould be supervised to ensure that they do not play with theproduct.
5. For duct or partition mount, precautions must be taken to avoid the back-flow of gases intothe room from the open flue
of gas or other open-fire appliances.
6. If the supply cord is damaged it must be replaced by the manufacturer,its service agent orsimilarly qualified persons in
order to avoida hazard.

Part No. INST- FSW 08/12 Page 3 of 3