FAR EAST Stockpot User manual

Stockpot Stove User Manual
Section 1:
Installation Instructions
Section 2:
Operating Instructions
Section 3:
Cleaning & Maintenance
WARNING: THE STOCKPOT AND ITS PARTS ARE HOT. BE CAREFUL WHEN OPERATING,
CLEANING OR SERVICING THE STOCKPOT RANGE
Improper installation, adjustment, alteration, service or maintenance can cause property damage,
Injury or death.
Read the installation, operating and maintenance instructions thoroughly before installing or
servicing this equipment.
For Your Safety
Do not store or use gasoline or other flammable vapours and liquids in the vicinity of this or any
Other appliance.
Important
Contact your local gas supplier if you smell gas near this equipment.
The appliances must be installed by a competent person in compliance with the Installation and
servicing instructions and the national regulations in force at that time.

Section 1: Installation instructions:
1) Set the unit in the position under the extraction hood with adequate ventilation
2) Make sure the floor is level
3) Place largest pot to be used on the stove to check clearance before connecting gas hose (minimum
clearance 6 inch from sides and back)
4) Gas hose should be connected at the rear of the stove. An accessible shut off valve should be
installed in line
5) The front of the unit must be kept clear to avoid restriction of air supply for combustion
6) The installation must conform with the local codes and with national fuel gas codes
Section 2: Operating instructions:
The stockpot stove accommodates a single pan.
The burner is controlled by a single knob (ON/OFF) supported by a pilot burner and flame failure
thermocouple
Controls: The Stockpot stove in controllable by the knob at the front. The knob can be turned clockwise or
anti-clockwise to operate the burner.
Lighting instructions:

Section 3: Cleaning and Maintenance
1) The unit should be cleaned every evening after daily use
2) The frame and burner may be cleaned with a soft brush or sponge
3) The jets of the burner should be cleaned once a year and must be performed by an authorized gas
service company. The jet type burner should be cleaned with a core brush and appropriate size
number drill
4) After cleaning, rinse with clean water and dry
5) Keep this book on hand for future reference