Faria Beede DM0100 User manual

Be sure all of the connectors are connected and the User
Interface has signal, power and reads “COMM” or “noCOMM”.
Press and release the “S” button to enter the STATUS MODE.
Pressing the “MODE” button will cycle through five status
displays.
GSM Signal strength
0 (no signal) This unit is not
equipped with a GSM processer
and there will be no signal read
here.
Satellite signal strength
0 (not available) or 5 (best signal).
Move the Satellite antenna around
until the User Interface displays
the best signal possible. 5 being
the best signal.
GPS Signal Strength
PDOP x 100 (a PDOP of 1.23 will
read 0123), 9999 (no GPS), lower
numbers represent a better
connection. Move the GPS
antenna around until the User
Interface displays the best signal
possible. The lower the number
displayed the better.
DM0100 - 2-Inch Telematics User Interface IS0388
Rev. A ecn 10402 06/2016
Warning
Operation
Made in the USA Faria Beede Instruments, Inc.
www.FariaBeede.com
Main Battery Voltage
Main battery voltage x100 (a main battery voltage of 12.34 will
read 1234) Back-up Battery voltage will read the same as the
Main battery.
Press the “S” button to exit the
“Status Mode” and return to
“Normal Mode”
Assistance Button
The Faria Beede MTU system is
equipped with an Assistance
Notification function.
Any person on the vessel can
request assistance by using the
2-inch User Interface.
Pressing and holding the “H”
button for 5 seconds will put the
MTU into the ASSISTANCE
MODE.
In this mode, someone on the
vessel has requested assistance.
The screen will display “HELP
SEND” indicating that the MTU
has requested assistance.
Once the request has been sent,
the screen will change to “HELP
SENT”.
This is to indicate that the MTU has sent out a request for
assistance. An assistance alert will be sent to those
individuals listed on the notification page, on the web site, by
e-mail or automated phone message.
After the e-mails and phone calls have been made the
interface screen will change to “HELP RECV”.
“HELP RECV” does not indicate that the people that have been listed on the “Notifications” page have received
the notification only that the notification has been sent.

Installation Diagram
For technical assistance, contact Faria Beede Instruments - Customer Service between 8:30 AM and 5:30 PM
Eastern time weekdays at [phone] or [phone].
J1 J2
J3
BLACK
Ground
RED
Main
Battery
+12-24V
B
A
HN0787
Serial # KWD304-VMS000 FPN:KTW304
PASS 02-28-09
SIM CARD
IRIDIUM MODEM #
FCC ID:PY76220511
User
Interface
MTU
Antenna connections are determined
by the type of MTU in use. Consult your manual.