FAS CARNIVAL User manual

1
CARNIVAL
TABLE FOOTBALL GAME
ASSEMBLY INSTRUCTIONS
Please keep for future reference
Adult Assembly Required
(0316)

2
ASSEMBLY INSTRUCTIONS
Please keep these instructions for future reference. Adult assembly required.
This table is not a toy & is intended for use by or under the supervision of adults.
Please do not sit, climb or lean on the table.
This table is intended for indoor use only.
Parts Identifier
1. Find a clean & level place to begin the assembly of your CARNIVAL table football game. You
will need a Phillips screwdriver, a 13mm & a 17mm spanner & a hammer. Remove all parts
from the box & save all packing materials until the parts have been inspected & the table is
assembled.
2. Attaching the legs – place the table onto the floor facing the correct way up. Open the table,
lift the lid & use the metal lid prop provided to keep the top open. Remove the poles, slopes,
legs & plastic parts bag from inside the table. Close the table & stand it up on its end so that
it can be opened 90 degrees like a book. Important – this should be carried out by 2 adults.
3. Make sure the legs are the correct way round (see below) & then attach the legs into the
slots underneath the table using the bolts, washers & nuts provided. Fit the rubber feet to
the bottom of each of the 4 legs.

3
Insert the coach bolts into the sides of the table & secure on the inside with a large star washer
& then a large nut. The flat head bolts should be inserted underneath the table & secured on
the inside with a washer, then a small star washer & then a small nut. The square neck of the
coach bolt will not fit into the round hole. Tighten the nut so that the neck breaks into the
laminate but do not over-tighten – this will not cause the laminate to crack. The mushroom
head of the coach bolt should just touch the laminate surface.
4. Stand the table up on its legs & prepare to fit the poles. Push the bars into the table, pushing
the handle-end of the pole through the hole first from the inside. Do not fit the handles onto
the poles at this stage.
Then starting from the blue score counters end of the table insert the poles as follows:
-Blue 1-man pole
-Blue 2-man pole
-Red 3-man pole
-Blue 5-man pole
-Red 5-man pole
-Blue 3-man pole
-Red 2-man pole
-Red 1-man pole
There should now be 4 poles on each side of the table with the red & blue teams facing each
other.
5. Now fit the pole bearings as shown in the diagram below. At both ends of the poles fit 2 half
moon bearings with legs to the inside of the table & then 2 half moon bearings without legs
to the outside of the table. Secure with 2 screws. Finally hammer on the handles to the end
of the poles.

4
6. If not already fitted, attach the blue & red score cubes into the flat top ends with the screws
provided. Make sure the ball slopes are fitted inside the table. Finally, fix the ball catcher to
the long side of the table as shown below:
You are now ready to play
Cleaning & Maintenance
Use everyday household glass cleaner for both the glass & the laminate surface.
Mightymast Leisure is the UK & Ireland agent for FAS Italian table football games
For sales & service contact:
Mightymast Leisure Ltd, 58 Bentwaters Park, Rendlesham, Woodbridge, Suffolk. IP12 2TW.UK
Tel: [phone]
www.mightymast.com inf[email protected]