FERRIOL MATRAT E-Joelette User manual

[Texte]
INSTALLATION OF THE KIT E-JOELETTE
N
O
U
V
E
L
L
E
G
E
N
E
R
A
T
I
O
N
NEW GENERATION
www.joeletteandco.com
CONTENTSU OF THE KIT

[Texte]
www.joeletteandco.com
PUT THE
JOELETTE IN
« TRANSFER
MODE»
REMOVE ALL OF THE CLIPS THAT
IMMOBILIZE THE BREAK HOSE
(EXCEPT ON THE SWINGARM)
REMOVE THE
BREAK LEVER
DISCONNECT THE
SHOCK ABSORBER IN
THE LOWER PART
REMOVE THE SPINDLE AND
THE SWINGARM
THE JOELETTE IS READY
TO RECEIVE THE KIT
ASSEMBLY STEPS

[Texte]
www.joeletteandco.com
CONNECT THE KIT TO
THE TRANSFER FRAME
WITH THE SPINDLE
CONNECT THE SHOCK ABSORBER TO
THE KIT BY USING THE SCREW AND
THE NUT PROVIDED
MOUNT THE ACCELERATOR AND
THE BRAKE LEVER PROVIDED AND
REPLACE THE CLIPS IN ORDER TO
IMMOBILIZE THE HOSE AND THE
ELECTRIC CABLE
TAKE THE BATTERY OFF ITS
SUPPORT
IN THE HIGHER PART,
MOUNT THE SUPPORT ON
THE JOELETTE WITH THE
M10X80 SCREW PROVIDED …
... AND THE SCREW M6X12
IN THE LOWER PART
CONNECT THE THROTTLE CABLE BY
ENSURING THE WHITE ARROWS ARE
ALIGNED. RUN THE CABLES BETWEEN
THE HANDLEBARS ADJUSTMENT TUBE
AND THE SUPPORT OF THE BATERY
CONNECT THE MOTOR POWER
SUPPLY CABLES BY ALIGNING
PROPERLY THE ARROWS

[Texte]
Specific information
- For the maintenance and precautions for use, read the general manual
attached to the package of the one-wheel Joëlette.
- To make the transfer of disabled persons from their wheelchair to the
Joëlette TWIN, apply the same procedure as for the classic one-wheel
model.
- Before going on a hike, make sure each safety pin is in place.
www.joeletteandco.com
YOUR IS READY
REPLACE THE BATTERY
ON ITS SUPPORT
IMMOBILIZE THE DIFFERENT CABLES
WITH THE PLASTIC HOSE CLAMPS
PROVIDED