FIBARO FGBHT-001 User manual

THE HEAT CONTROLLER
RADIATOR THERMOSTAT
Quick Start Guide

2
If you need help configuring FIBARO The Heat Controller,
follow our guides and technical manuals available at:
manuals.fibaro.com/en/hk-heat-controller
Support
Scan the code to
read the manual

3
Package Contents
Quick Start Guide, Quick
Manuals, Warranty Terms
Device
Every FIBARO The Heat Controller has a unique HomeKit Setup Code.
You will find the setup code on back cover of the Quick Start Guide.
Temperature sensor
(optional)
Maintenance key
M30 x 1.5
Danfoss RTD-N
Danfoss RA-N
Adapters. Depending on type of your thermostatic valve:
Proceed normally
Use adapter
Use adapter

4
FIBARO app
homekit.fibaro.com/app
Download FIBARO application from the App Store.

5
First launch
Connect the charger to the micro-USB
port to charge the device
Step 1
Fig. 2
Step 2
Disconnect the charger when the LED
ring pulses green (device fully charged)
Fig. 3
Step 3
Fig. 1
Step 4
Depending on type of your valve
proceed normally or use adapter
Dismount your current thermostatic
head
Fig. 4

6
First launch
Step 5
Mount the device on the valve and
tighten it by turning the cap clockwise
Step 6
Open the FIBARO app
and tap Add accessory icon.
Application will guide you
through the pairing process
Step 7
Use the included key to click the button
Fig. 5
Fig. 7
If you have already set up another
accessory tap the + icon
!
Button
Fig. 6
Add accessory

7
1. Use the included key to press and
hold the button. When the LED
ring glows yellow, release the button
2. Click the button again immediately
to confirm
3. The device will reset to factory
defaults and will be put in Standby
Mode. Click the button to activate
it again
Resetting The Heat Controller to factory defaults
Fig. 9
1. Use a coin to open the battery cover
by turning it counter-clockwise
2. Remove the sticker underneath
the battery. Use coin again to close
the battery cover
3. Press and hold the button on
The Heat Controller. When the LED
ring glows blue, release the button
and click again immediately to confirm
4. Click the button on the Temperature
Sensor, the LED diode will start
blinking blue
5. The LED ring on The Heat
Controller, will blink green 5 times
if the connection was successful
Sensor pairing
LED diode
Fig. 8

© Fibar Group S.A.
All rights reserved
Made in Poland
www.fibaro.com
Room: ..........................................
105449610101
Write down the location of the device.
HomeKit Setup Code is needed to securely add accessory
to your home. You may need it in case of re-pairing.
Remember to keep it in safe place. Nobody but you has a copy.
FIBARO cannot recover the HomeKit setup code for you.