FilterWater FW-PRO User manual

FilterWater.com
FW-PRO BOTTLELESS COOLER

A
to
Installation Process
1) We start out by finding the nearest cold water source.
It’s usually located under a sink.
2) We install an Angle Valve Adapter onto the cold water valve and the other
end to the kitchen faucet line. The ¼” water cooler tube line will be
connected to the Angle Valve Adapter by quick connect to the ¼” insert.
3) Then we run our poly tubing from the water source to the water cooler.
A small hole is cut in the back of the cabinet, and we “snake” our waterway
inside the wall and to the ceiling. Once it’s above the drop ceiling, it’s easy
to run it to your cooler location.
4) Once we get the waterway above the cooler, we snake it back down the
wall and out a small hole that is covered with a cable plate.
5) Finally, we just plug in the cooler and turn on the water under the sink.
FilterWater . c o m
9

Mailing Address:
FilterWater.com
P.O.Box 968
Southampton, PA 18966
USA
http://www.FilterWater.com
Tel. [phone]
Fax [phone]
Email: [email protected]m
10