Fineart FINE 2970W/1080C User manual

--2
c
WARNING!
Read the safety precautions in this section before installing,
powering, operating or servicing this product.
After receiving the fixture, please unpack and check if there is any damage due to
transportation. If any obvious damage or flaw is found, do not put it into use and
co-ntact the distributor or manufacturer as soon as possible.
This fixture is intended for professional use .only
When operating the fixture, attentions should be drawn to fire/electric-
shock hazards and lethal injuries caused by fall.
Read this User Mannual before mounting and ennergizing the fixture.
Observe the safety guideline and notice the warnings both in this User
Mannual and on the fixture.
Yet any safety concerns not covered hereby, contact the distributor
or service hot-line.
The fixture should be kept dry and avoid working in presence of moisture,
over-heat or heavy smokes.
Protection against over heat
The following symbols are used to identify important safety information on the product
and in this manual:
FINE 2970W/1080C STROBE LED is suitable for indoor environment;
its protection rating is Ip20.
40
a

-3-
------- m
0.2
Please do not install the fixture onto combustible surface.
Do not attempt to bypass the thermostat switch or fuse.
Replace defective fuses with specified ratings only.
Keep flammable materials far away from the fixture. Minimum distance
from the flammable materials is 0.5m.
Under the steady working state, the max temperature of exterior surface
of FINE 2970W/1080C STROBE LED is 70 , Please℃don’t touch the
moving head during movement.
The minimum distance between the fixture and the lighted objects is
0.2m.
Do not place any filter or other object onto the optical lens.
Allow the fixture to cool for at least 15 minutes before transit.
Do not revise the fixture or install any parts not from Guangzhou CHAI
YI LIGHT Co.Ltd.
Protection against electrical shock
All electrical connections must be performed by a qualified person with
technical certificate.
Make sure that the mains power supply you use is up to local construc-
tion and electronic code regulation, the over-load protection reliable
earthing is essential.
Each fixture must be grounded correctly, and be installed according to
related regulation.
Disconnect the fixture from mains supply before replacing any fuse.
Avoid using the fixture in damp environment.
Protection against burning or fire
Protection against explosion
Shields must be replaced if they have become visible damaged to such
an extent that their effectiveness is impaired.
Protection against injury due to falls
To inspect that the structure and the truss hooks are in good condition
and can bear about 10 times the weight of the fixture.
Ensure the cover and all riggings are securely fastened, safety wire is
necessary to use as a secondary attachment.
Block access below the working area and work from a stable platform
while installing, servicing or moving the fixture.
The natural working temperature should be lower than 40 degrees. If
the ambient temperature exceeds 45 degrees, please stop operating
the unit immediately.