Finishing Touch FLAWLESS User manual

Thank you for your purchase of FLAWLESS™, the easy and convenient facial hair remover.
Getting Started / Charging Battery
• Prior to rst use, fully charge unit (approximately 3 hours to full charge).
• Insert micro USB end of the charging cable into the charging port (b)
located at the bottom of the unit (a) (Image 1).
• The charging LED Indicator Light (c) will turn RED while unit is charging.
• When charging is complete, the LED Indicator Light (c) will turn OFF.
How to Use
• Remove the FLAWLESS™ cap (Image 2).
• Slide the switch located on the side of the unit upward into the “ON”
position (Image 3). The light will automatically turn on when the unit
is “ON”.
• Gently press the head of the unit at against your skin. The unit should not
be on an angle. Proceed making small circular motions to remove unwanted
hair (Image 5).
NOTE: It is normal for the head to become warm with use.
Cleaning (Be sure unit is o)
• Twist the rotating hair removal head counter-clockwise and lift o (Image 4).
• After each use, clean the head by using a brush (included) to wipe away the
hair residue.
• Empty any hair from the body of the FLAWLESS™ unit by turning it over and
gently tapping the sides.
• To put the hair removal head back on the unit, line up the “groove”
indicators on the cap with those on the unit and twist clockwise
(Image 4).
Tips & Pointers
• For superior results, use on hair ¼" in length or less.
• If the unit begins to slow down, clear the hair removal head and body of any
hair residue. If the unit is still running slow, charge the battery.
• Gentle enough to use every day.
• For airbrush-like make-up application, use daily.
NOTE: Prior to rst use, test the FLAWLESS™ on a small area. If any sensitivity
or allergic reactions occur, discontinue use immediately. Do not use your
Flawless on sensitive or irritated skin.
Replacement Head
For optimal results it is recommended that you replace your Flawless head
every 6 months. The head may need to be replaced sooner if the Flawless
loses performance or if the head becomes chipped or damaged in any way.
Go to www.awlessheads.com for special replacement head oer.
IMAGE 2
IMAGE 3
IMAGE 5
IMAGE 1
IMAGE 4
Warning
• Keep out of reach of children.
• Do not use on irritated skin. Discontinue use if skin
irritation occurs.
• Exercise caution when using around eyes.
• Do not rinse head under water.
• Do not submerge unit under water.
• Store in a cool dry place when not in use.
• This unit contains a Lithium Ion battery. Dispose of in
accordance with all applicable federal, state and local
regulations.
• Do not dispose in re.
Rechargeable Facial Hair Remover
Must fully
charge unit
prior to
rst use!
NOTE:
Charging Port (b)
LED
Indicator
Light (c)
Bottom
of Unit (a)

Distributed by: Wayne, NJ 07470
Made in China © 2017 Ideavillage
[email protected]
FTFLAWDLX071117
Charge unit (3 hours to full
charge). (Image 1)
Remove cap. (Image 2)
Turn Unit On: Just slide gold
switch upward. (Image 3)
To Remove Hair: Use in a
circular motion. (Image 4)
IMAGE 2
IMAGE 1
IMAGE 3
IMAGE 4
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
U.S. & International Patents Pending
1.
2.
3.
4.
QUICK START GUIDE
Rechargeable Facial Hair Remover
Charging Port
LED
Indicator
Light
Bottom
of Unit