6
USING LOOSE LEAF
VAPING LOOSE LEAF
• Touch and glow. Place fingers on both touch sensors to
start heating.
IMPORTANT: Place fingers lightly on touch sensors (as if you are
tapping a smartphone). Do not press down or use excessive force.
• The LED will blink green for three seconds and turn
solid green when it’s ready. Watch for the glow!
• On subsequent touches, the LED will turn solid green
immediately.
• Continue to hold the touch sensors while you inhale for
10 seconds with a long, deep draw.
• Release touch sensors to stop heating.
• After a few draws, stir the contents of the heating
chamber.
• For a denser vapor, inhale more deeply for a few more
seconds. To further customize vapor, see the Tips and
Tricks section later in this document.
PLEASE NOTE: The Firefly will turn off after 30 seconds of holding the sensors, and the heating coil will not glow as bright towards the end of a vape session.