FJGear FJ-201HUA User manual

2 Ports USB 2.0 HDMI KVM Switch
Model: FJ-201HUA
User Manual
Product Port Diagram: Connection:
Switching Method:
1. Switch between any port by the button on the front of the product. Hotkey does not support linux,
Unix
2. Keyboard hotkey switch:
a. Double-click Scroll Lock (or Num Lock), in order to cycle.
b. Ctrl+Alt+port code, any port switch (this function should install software).
3. Through the mouse for any port switching or automatic scanning cycle switching (interval 10-60
seconds can be set arbitrarily). This feature is to install the software.

Installation Instructions:
1. After all the devices are connected (as shown in the product wiring diagram below), press the button
to switch the functions one by one. After the boot is completed, you can switch the buttons or
double-click the keyboard Scroll Lock (or Num Lock) to view or edit each. Port file information. When
the port light is flashing, no switch button can be operated. Since the switch is reading data, the light
can be switched after the light is on.
2. Install the “FJ-USBKVM” software on the CD-ROM to the computer (device) one by one, then double-
click the “Fengjie Yingchuang UBSKVM” icon on the desktop to run it. There is a number (connected)
at the bottom right of the screen. Or FJ (not connected) shows that this number indicates the
number of ports of the KVM switch. Note: The “mouse hotkey switching software” only needs to be
installed once. After the next boot, double-click the desktop USB KVM icon to run it.
3. After completing the “4” step, you can use the mouse or keyboard hotkey (Ctrl+Alt+port code) to
switch between any port or automatic scan cycle. The initial hotkey code is the number 1, 2, 3, 4 of
the primary keypad, and the automatic scan interval is 10 seconds.
4. If the keyboard hotkey (Ctrl+Alt+port code) cannot be switched, use the right mouse button to click
the number on the bottom right of the screen to enter the “Settings” interface, set or confirm the
hotkey code or scan time of each port. Click “OK” to save when finished. And close the window. This
keyboard hotkey (Ctrl+Alt+port code) can be used to switch any port.
Right click on the number at the bottom right of the screen and a menu pops up. Click "Switch to
computer 1" in the menu, or "Switch to computer 2", you can easily switch. Go to the port you clicked.