Fleximounts WR26MB User manual

Item No.WR26MB
Installation Guide
800 lbs/pack
1600 lbs total
(evenly distributed)

Package Contents
(A) Parts Included (B) Screw Set (4 packs）
B1 (6 pcs)
Each contains
B2 (6 pcs) B3 (6 pcs)
( ) Tools Needed for Assembly
c
Screwdriver
01 02
①
②
③
④
⑤
Foldable Shelf
(2 pcs)
Shelf Bracket
(8 pcs)
Level
(1 pc)
Socket Wrench
(1 pc)
Installation Template
(1 pc)
Velcro
(4 pcs)

STEP 1-A: Install Shelf Brackets into Wall Studs
1.Decide the height and use template and level to mark the holes. Make sure hole
locations are level before drilling holes.
Wall
Wall
Caution:Make sure
that the shelf brackets
are completely fixed on
the wall without gaps
toprevent property
damage or personal
injury.
60mm
Φ4.5mm
Shelf Bracket
Shelf Bracket
2.Drill 60mm deep holes with 4.5mm drill bit.
3. Install the Shelf Brackets ② with washers (B3) and screws (B1) with a wrench
(Combine Socket Wrench③ and screwdriver).
B3
B1x24 x24
Installation Steps
03 04
+=
Level ③ Wall Studs
Installation
Template ④
Wall Studs
12‘
16'
18'
24'
The template is designed for
studs12",16",18" and 24"apart.
12'

Level ③
STEP 1-B: Install Shelf Brackets into Soild Concrete Wall
1.Decide the height and use template and level to mark the holes. Make sure hole
locations are level before drilling holes.
Wall
Wall
12‘
16'
18'
24'
Caution:Make sure
that the shelf brackets
are completely fixed on
the wall without gaps
toprevent property
damage or personal
injury.
The template is designed for
studs12",16",18" and 24"apart.
60mm
Φ10mm
Shelf Bracket
Shelf Bracket
2. Drill 60mm deep holes with 10mm drill bit.
3.Screw in the metal expansion bolts (B2) firstly and then install theShelf Brackets ②
with washers (B3) and screws (B1) with a wrench (Combine Socket Wrench③ and
screwdriver).
05 06
B3
B2x24 B1x24 x24
+=
Wall
Installation
Template ④
12'

STEP 2: Unfold Shelf
Wall
STEP 3:Place and Attach Shelf
Insert the
Shelf ① into
the groove.
Flatten the
Shelf ①.
STEP 4:Install Velcros
CAUTION
Tighten the Shelf ① and Shelf Brackets ② with the Velcros ⑤ at the position shown in the
figure.
Wall
This product contains small items that could be a choking hazard if swallowed. Keep these items away
from young children.
·Make sure these instructions are read and completely understood before attempting installation. If you
are unsure of any part of this installation, please contact a professional installer for assistance.
·The wall must be capable of supporting the combined weight of the garage rack and your stuff
Otherwise, the structure and weight capacity of the ceiling must be reinforced.
·Proper tools must be used. A minimum of two people are required for this installation. Failure to install
properly can result in property damage or serious injury.
·Check joint parts every two months, making sure the screws have not loosened.
·This product is designed to be installed on a wooden wall or solid concrete ceiling. Before installation,
make sure that the weight capacity of the wall will support the combined load of the rack and your stuff.
Never exceed the maximum load capacity of the product 800lbs/pack,or else it may result in product
damage or physical injury.
Note: This product is intended for indoor use only. Use of this product outdoors could lead to product
damage or physical injury.
07 08
Velcro ⑤

09