Flextrack Lommy Pro T User manual
Congratulations on your new Lommy Pro T
This guide will give you a short introduction
to the functions and tting of the unit.
1
3
2 1
5
4
Lommy Pro T overview
1. Hole for mounting
2. On/off button
3. Light indicator showing the
status of the Lommy
4. USB-port for charging
5. Connection to installation kit
[/lommy pro T ]
Quick Start Guide
Lommy Pro T
For technical questions, please contact Flextrack Support:
support@extrack.dk
www.extrack.dk
Quick Start Guide
Getting started
Use the diagram below as a guide for installing your Lommy Pro T.
As a standard, the cables and installation kit are enclosed with your
Lommy Pro T and will be there when you receive it.
In order to turn the unit on, briey press the on/off button. To turn off the unit, press the on/off
button for 5 seconds until the yellow LED starts blinking fast. Release the button for less than
2 seconds before pressing it briey again, after which the Lommy Pro T will switch off.
The placement of your Lommy Pro T
The technology in the unit relies on GSM communication and GPS postioning via internal antennas.
Materials like concrete and most metals will dampen the GSM/GPS signals signicantly, and
placement behind such materials should be avoided.
On the other hand, the signal can pass through materials like plastic, glass ber, wood and
glass of moderate thickness.
Note: Some windshields can contain a thin coating of metal oxide, that will weaken or hinder
the signal.
Examples of good placements in the car:
• Directly under the outside of the dashboard
• The center console, between the front seats
• The top of the back seat’s backrest
• Under the rear shelf, if this isn’t made of metal
When a location has been chosen, it is highly recommended to do a test run, where the
performance under real working conditions is observed over a suitable time span.
A 1A fuse should be fitted
close to the battery!
White. Connect to battery +
Black. Connect to ground/battery -
Brown. Input 1. Has to be connected to “+” at ignition
Grey. Input 2 (extra equipment)
Blue. Output 1 (extra equipment)
Installation
Quick Start Guide
Flextrack, Høgevej 19,
DK-6705 Esbjerg Ø, Denmark
[ version 1.0 ]
Setting up and monitoring your Lommy Pro T
via your computer or portable unit
If you have a subscription with Flextrack, then you can log in at www.extrack.dk to
set up and change the conguration and alarm destinations.
Your username and password are the 10-digit serial number found on the back of
your Lommy Pro T.
When you’re logged into the website, you can see the status and position of your Lommy Pro II,
as well as a range of other useful information.
If your vehicle or another possession is stolen, you can use this function to tell the police where
it’s been and where it is now, so you can get it back.
Light indicators (LEDs) on the front of the device
Light colour
Name
Blinking
patterns
Continuous
light
Others
Yellow
SYS
2 short blinks:
Connected to the
Internet
Is in the process
of starting up, or is
low on battery
One blink:
No connection
to the server
Blue
GPS
One blink:
No GPS signal
Several blinks: GPS
is connected. The
number of blinks =
the number of
satellites connected
Red
CHG
2 short blinks:
Charging
Fully charged
Blinking slowly:
Switching off due
to low power
Green
GSM
Blinks sporadically:
OK
Blinking
continuously:
Problem with the
SIM card
Quick Start Guide
For technical questions, please contact Flextrack Support:
support@extrack.dk
Flextrack, Høgevej 19,
DK-6705 Esbjerg Ø, Denmark
[ version 1.0 ]
