Flybar Swurfer User manual

INSTAATION INSTRUCTIONS
Step 1:
Fold rope in half by aligning ends. Drape rope evenly over the branch.
Tip : To install without a tall ladder, connect string or twine to a beanbag or
a weighted sock. Make sure it’s long enough to make it over the branch and
back to the ground, and throw the weighted object over the branch. Then, tie
the string to the center of the rope loop, and pull it up over the branch.
Step 2:
Pull the ends of the rope through the loop so it wraps tightly around the branch.
Repeat steps 1-2 with the other rope. Both ropes should be placed 24-36 inches
apart when done.
Step 3 :
Lace the rope
through the handles.
Step 4:
Lace rope through holes on your Swurfer board. Tie a double overhand knot
beneath the board, and level your Swurfer by adjusting the four knots.
Trim rope and melt ends with lighter to prevent fraying.
Note: Rope must be taped prior to cutting,
otherwise it will fray before you melt it.
STEP 5:
Visit www.swurfer.com
Show us where you hung your #Swurfer!
Swurfer.com
Distributed by The ROB Company, LLC
PO Box 13801 • Charleston, SC 29422
Checklist for Installation:
___ Blade
___ Tape
___ Flame
RIGHT WRONG WRONG
24 - 36” APART
WRONG
RIGHT WRONG WRONG
RIGHT WRONG WRONG
WARNING: You should have the same amount of distance from the trunk of the tree or any other objects
as you have from the ground to the branch. Swinging with the Swurfer® Kiçk involves inherent risk that
can cause serious injury or even death. Purchaser and users assume all risk, responsibility and liability for
use of the Swurfer® Kiçk, including any resulting loss or damage to persons or property. Flybar Inc.
assumes no liability arising from the use or application of any of its products and specically disclaims
any and all consequential and incidental damages. Flybar Inc. makes no warranty representation or
guarantee regarding the safety or suitability of its products for any given purpose. The purchaser or user
assumes the responsibility for installation and assembly PLEASE CHECK THE ROPES, HANDLES AND
BOARD BEFORE EACH USE AND REPLACE IF SHOWS SIGNS OF WEAR. Be aware of your surroundings, and
Swurf within you limits.
RIGHT WRONG
RIGHT WRONG WRONG
24 - 36” APART

WRONG
24 - 36” APART
WRONG
INSTRUCTIONS FOR USE:
1. Adjust handles to be midway between
your waist and armpit.
2. Position feet shoulder width apart on
the Swurfer board.
3.
and keep your knees bent.
4. To get o your Swurfer, hold the handles
while sliding down to a seated position.
RECOENDED CLEARANCE
MAXIMUM
PERFORMANCE
GOOD
PERFORMANCE
MINIMUM
10’
6’
10’
6’
• durable plastic board
• adjustable grip handles
• looped nylon rope
• easily hangs from trees
or swingsets (Swingset
bracket required to
swing perpendicular to
swingset)
Features:
@TheSwurfer Swurfer.com
Visit www.swurfer.com
Distributed by
Flybar, Inc. 323A Fairfield Rd Freehold, NJ 07728
WARNING: Regularly check your tree branch, as well as the ropes and swing itself. Look for splitting,
fraying, missing bark, or other damage, and repair right away. A properly installed swing should not
cause any damage or grooves in the tree. Replace rope every couple of years.