FNX Solar Solarix 60 User manual

Quickstart Guide
Solarix 60
1. Unfold the solar panel completely and make sure that all the cells are facing directly to the sun.
2. Using the included DC cable connector, plug one end to the DC socket on the solar panel control box shown
below.
3. Plug the other end to the power input socket of the power station. Below shows the FLEX-GEN 200 unit for
reference purposes.
4. With enough sunlight, the power station will indicate charging by blinking the charge percentage value on the
display.
5. The charging is finished once the display indicates 100%. Unplug the solar panel from the unit. Fold the solar
panel for storage.

Care and Maintenance Instructions:
•Always fold the solar panel when not in use. This protects the solar cells from external elements.
•Do not step on the solar panel. It could crack the cells that could lead to reduced solar conversion efficiency or
premature failure.
•The product is made of durable water-resistant materials. It is designed to repel water droplets but not designed
to be soaked wet in water. Doing so may damage the controller and/or the cells, causing premature failures.
•In the case that the material gets wet, let it dry first before folding the solar panel. This prevents any moisture
from getting trapped inside when the solar panel is folded for storage.
•Keep the solar cell surface clean. Use a clean damp cloth to gently wipe off any dirt on the surface.
FNX-Solar Power Solutions
www.fnxsolar.ca