FOCO Barcontainer User manual

Assembly instructions
Barcontainer
FOCO® containers

Equipment
- Screwdriver or drill (Phillips head)
- 13 mm wrench
- 19 mm wrench
- Torque wrench (13 mm and 19 mm inserts)
Manual:
First, using the 19 mm and 13 mm wrenches, remove the screws that hold the floor and roof package to-
gether, save these screws. Also unscrew and save the lifting eyes on the roof.
Then remove the wooden blocks at the corners of the package and the iron blocks in the middle, these
are not required for assembly, but may be useful in leveling the container.
FOCO® containers

Then the panels are removed from the package, do not place them on the asphalt this can cause dama-
ge in the form of dents or scratches. Protect the panels with leftover wood or plastic from the package.
Always mount a container on a straight level surface and start laying the floor.
Next, the panels are placed in the correct position (photo above). They are mounted using the 13 mm and
19 mm screws from the package with a corresponding washer in between (photos below). During assem-
bly, the panels should be held by an extra person to keep them from falling to the floor. Once the panel is
attached to the floor it can be released unless there is wind. The side panels (walls) are placed first, then
the door is placed.
FOCO® containers

Then the two panels are mounted using a 13mm screw, a nut and two washers. The screw is fixed with the
nut in the holes with a washer on both sides for protection.
Each corner of a container contains three fixing holes where a screw must be placed.
1. 2. 3.
4. 5. 6.
Using the key, the cylinder lock is attached (photo 1). Then the door handle is attached (photo 2) and
must be screwed on both sides using 3 screws (photo 3 + 4). Then the lock is fixed with the long screw on
the side of the door (photo 5). Finally, the metal protection parts are placed on each latch and on each
keyhole (photo 6).
FOCO® containers

The roof must be placed with (at least) four people. First, stand next to the container with everyone, then
lift the roof overhead at the same time. Place the roof on the container until about halfway up the roof.
Then half the people go into the container, lift the roof through and lay it properly. The roof is in place
when it has fallen completely into the slots.
Then the roof is mounted using a 13 mm screw, and nut and two washers, as shown in the picture above
Now screw down the rain gutter with three screws at the top of the canopy panel, it is best if someone
from outside holds the screws and someone else inside tightens the screws.
FOCO® containers

Finally, the crane eyes are reattached to the roof of the container, no tools are required for this.
Now attach the handles to the awning with the screws that are left. There are three holes, make sure the
handles are placed on the outside at the top and inside at the bottom as shown in the picture below. The
handles should be attached from the outside and inside.
FOCO® containers