FONESTAR FOG-11 User manual

FOG-11
PROFESSIONAL FOG MACHINE, 700 W
INSTRUCTION MANUAL
FOG-11_MANUAL_(EN)_20170322_Maqueta ión 1 22/3/17 14:34 Página 1

EN
- 2-
We take this opportunity to thank you for buying this product.
We recommend you read the instruction manual before switching on the machine and follow the instructions
that are given. eep the manual for future reference.
SECURITY AND THE ENVIRONMENT
ELECTRICAL SECURITY
Check that the current in the mains connection where the machine is to be installed corresponds to the
power supply of the machine.
To avoid damaging the equipment, electrical shocks, fire or physical injury when you connect or disconnect
the equipment from the power supply, pull the plug firmly out of the mains socket holding the plug, never the
cable.
Always do this with dry hands.
eep the power supply cable far from sources of heat. Do not put heavy objects on top of it or change it.
Clean dust and dirt off the power supply cable regularly.
Do not open the machine; you could get an electric shock.
CAUTION
While installing the machine, make sure it is switched off and unplugged.
Do not open the machine. Touching the internal parts is dangerous and you could receive an electric shock.
The machine must not be splashed or dripped on. Never place recipients with liquid inside on the machine.
Do not place anything inside the machine.
LOCATION
Place the equipment on a horizontal surface with enough space around it to allow ventilation.
Avoid direct sunlight, heat sources and excessive dust.
Do not place the machine near magnetic fields or static electricity.
Do not use surfaces which vibrate or receive impact.
Do not pile machines on top of one another.
VENTILATION
Never block or cover the ventilation slits on the machine.
Do not expose it to direct sunlight or place it near sources of heat.
PERIODS OF INACTIVITY
When the machine is not going to be used for a long period of time, disconnect it from the mains.
If you are using an adapter, take into account that it will continue using electricity even if the machine is
switched off. If it is not going to be used for a long period of time, disconnect it from the mains.
THE ENVIRONMENT
To save energy, switch the machine off when you are not going to use it for a long time. The machine could
contain substances that are harmful to the environment or human health. To minimize the effect of these
substances the machine must be correctly managed and recycled when you decide to dispose of it.
When you dispose of it remember: it cannot be thrown into a conventional rubbish bin.
If it contains or uses batteries, these must be disposed of separately.
The machine (without batteries) must be disposed of correctly. Put it in a container specially intended for the
collection of electronic and electrical appliances, at the dump or hand it over to the dealer when you purchase
similar equipment, so that the dealer can dispose of it correctly (at no added cost).
FOG-11_MANUAL_(EN)_20170322_Maqueta ión 1 22/3/17 14:34 Página 2

EN
- 3-
.SIGNIFICANCE OF THE SYMBOLS ON THE MACHINE*
The symbol formed by the expression “Class 1 laser product” written in a rectangle
indicates that visible or invisible laser radiation could be produced. Avoid direct expose to
the laser.
The symbol formed by a ray of lightening inside a triangle shows that the machine has
connection terminals or a circuit with areas with a current which could cause an electric
shock, even in normal working conditions.
The symbol formed by an exclamation mark in a triangle shows that the instruction manual
must be referred to for information on how the machine works and its use.
The symbol formed by one square inside another square shows that the machine has
double electrical insulation.
The European Community symbol shows that the machine complies with the current
European Union legislation, as well as its transposition to local legislation.
The symbol of a rubbish bin crossed out and over a horizontal line shows that when the
product is disposed of it must be done properly, placing it in a special selective electronic
and electrical equipment container or through a dealer when purchasing a similar product,
at no additional cost. It also shows that the machine was put on the market after 13th
August 2005 (European Community Directive 2002/96/CE of Electrical and Electronic
recycling, and its Spanish equivalent R.D.208/2005).
In accordance with what is set out in the aforementioned decree, FONESTAR is registered
in the RAEE (Registro de Aparatos Eléctricos y Electrónicos) in a special section REI
(Registro de establecimientos Industriales), with the entry number 001851.
*It is possible that some of these symbols do not appear on the machine.
EXEMPTION OF LIABILITY
The characteristics of the equipment and the content of the manual can change without forewarning.
FONESTAR, S.A. does not assume responsibilities regarding the inappropriate use of the equipment or the
information supplied in this instruction manual, and specifically disclaims any implied liability for marketability
or fitness for any other use.
All rights reserved by FONESTAR, S.A.
FOG-11_MANUAL_(EN)_20170322_Maqueta ión 1 22/3/17 14:34 Página 3

EN
- 4-
DESCRIPTION
- Professional fog machine, 700 W power.
-Remote cable or remote control switch on.
CONTROLS AND CABLES
REAR PANEL
1.- Remote cable input, DIN 5 connector.
2.- Protective fuse.
3.- Power supply outlet.
4.- Microswitches which allow the reception channel to be selected in order to control several fog machines
using the same remote control. For more information, consult the Remote control section.
5.- Fog machine LED on/off indicator.
6.- FOG: button which activates the expulsion of fog.
REMOTE CONTROL
1.- A-B-C-D: activates the expulsion of fog from the machines which are located in the corresponding
positions. Press and hold any of the 4 buttons until the flow of fog required is reached.
Operating is as follows:
Button A activates all the fog machines that have the microswitch 1 selected in the rear panel.
Button B activates all the fog machines that have the microswitch 2 selected in the rear panel..
Button C activates all the fog machines that have the microswitch 3 selected in the rear panel..
Button D activates all the fog machines that have the microswitch 4 selected in the rear panel.
FOG-11_MANUAL_(EN)_20170322_Maqueta ión 1 22/3/17 14:35 Página 4

EN
- 5-
CONNECTION AND OPERATING
- The device has been designed to be used in closed spaces. Do not use outdoors. Place the device in a
ventilated area and on a flat surface. Remove the lid from the fog liquid deposit, fill it with certified liquid
fog and close the lid. The use of other products could damage your device.
- Connect the remote cable to the input using the DIN 5 connector in the rear part of the device. Connect
the device to the mains supply.
-The warm-up time finishes when the two red LED remote cable indicators light up. At that moment, the fog
machine is ready to be used. To activate the expulsion of fog, press the green button on the remote cable
or the corresponding button on the remote control until the required flow is reached. The red LED indicators
will go out whenever the device reaches its maximum temperature, proceeding to chill. Once the necessary
temperature is reached, the red LED indicators will light up again allowing its use.
- If the device is not going to be used for a long period of time, it is recommended that it is disconnected
from the mains supply.
SAFETY RECOMMENDATIONS
-Do not leave the fog machine operating without liquid in the deposit, as this could cause damage to the
pump as well as the heating element.
- Do not leave liquid in the open air. Always close the fog deposit lids and the machine deposit immediately
after filling the deposit.
- Never add inflammable liquids of any type (petrol, gas, perfume) to the liquid fog.
CLEANING THE FOG MACHINE
- After approximately 40 hours use, it is advisable to clean the machine using a solution composed of 80%
distilled water and 20% white vinegar, to avoid the accumulation of residue on the device’s heating
element.
- When the device is unplugged and has cooled down, empty the machine completely. Pour the cleaning
solution into the deposit. Connect the device and wait for it to heat up. Switch the device on in a well
ventilated place until the deposit has emptied. If cleaning has finished, fog liquid can be put in the deposit
again.
FOG-11_MANUAL_(EN)_20170322_Maqueta ión 1 22/3/17 14:35 Página 5

EN
- 6-
TECHNICAL SPECIFICATIONS
FOG-11
CHARACTERISTICS Professional fog machine.
700 W power.
RF remote control.
Warm-up time: 5 minutes.
LED indicator for optimum operating temperature.
Automatic thermostat.
Activation using remote control, remote cable or push button on
the back panel.
DEPOSIT CAPACITY 1 litre
BLAST RANGE 7 m
OUTPUT VOLUME 170 m3/min
POWER SUPPLY 230 V AC, 700 W
DIMENSIONS 195 x 133 x 260 mm depth
ACCESSORIES Adjustable fixing mount
3 m remote cable
RF remote control
FOG-11_MANUAL_(EN)_20170322_Maqueta ión 1 22/3/17 14:35 Página 6

DECLARATION OF CONFORMITY
FONESTAR SISTEMAS S.A.
Polígono de Trascueto s/n
39600 Revilla de Camargo, Cantabria (Spain)
Declares, under its responsibility, that the following equipment:
Description: Professional fog machine
Brand: FONESTAR
Model: FOG-11
complies with the European Community directives 2004/108/EC on Electromagnetic Compatibility,
2006/95/EC on Low Voltage and 2011/65/EU on the restriction on the use of certain dangerous
substances in electrical and electronic appliances (RoHS).
Santander, 11 th December 2014
Juan Vallejo
Technical Engineer, Sales Department
WARRANTY
This product has been tested and has passed the corresponding quality control prior to being put on the market.
FONESTAR guarantees the suitability of the product for its specified use during a period of 2 years from the delivery date
and commits itself to repair or substitute the goods as expressed in the Spanish law ‘La Ley General para la Defensa de los
Consumidores y Usuarios, Real Decreto Legislativo 1/2007 16 Noviembre.
The lack of conformity in the first six months after purchase, due to a manufacturing defect, will be rectified with no more
than showing the proof of purchase. After six months FONESTAR reserves the right to demand proof of the product being
sold with that problem.
This warranty does not include damage produced by: inappropriate use or negligence, accidents, worn out parts due to use,
breakages, burns, spilt liquids or other substances, excessive humidity, battery deterioration and internal manipulation of the
device, the software or its components by unauthorized persons, and in general any use that is unrelated to the nature and
purpose of the product.
If any service is needed during the warranty period because of lack of conformity, please contact the business or distributor
where the product was purchased in no more than 2 months after being conscious of the problem. It is only necessary to
contact FONESTAR if it is impossible or imposes an undue burden for them to solve it..
To benefit from this warranty it is necessary to show the proof of purchase with the date clearly visible, with no corrections
or crossing out
This document adds information, and never decreases the consumers’ rights, which in all cases are protected by the Spanish
law ‘La Ley General para la Defensa de los Consumidores y Usuarios, Real Decreto Legislativo 1/2007 16 Noviembre.
FONESTAR is a member of ECOEMBALAJES ESPAÑA, S.A. “ECOEMBES”, with number 03497 and all our products
carry the symbol, backed by our membership and subscription to the above mentioned organization with the recycling
and subsequent management of our packaging.
FONESTAR, S.A. - NIF: A28780443 - Polígono Trascueto - 39600 Revilla de Camargo, Cantabria (SPAIN) www. onestar.com
EN
-7-
FOG-11_MANUAL_(EN)_20170322_Maqueta ión 1 22/3/17 14:35 Página 7

www.fonestar.com
FOG-11_MANUAL_(EN)_20170322_Maqueta ión 1 22/3/17 14:35 Página 8