FONESTAR SPR-566P User manual

SPR-566P
ADJUSTABLE AND EXTENDABLE
CEILING MOUNT FOR PROJECTORS
INSTRUCTION MANUAL

EN
- 2 -
DESCRIPTION
-Adjustable and extendable ceiling mount for projectors. For installation on horizontal and angled ceiling,
or vertical surfaces.
- 40º horizontally adjustable.
- ±20º vertical tilt.
- ±20º side tilt.
- 3 cm horizontal line adjustment.
- Can be installed in ceilings with angles from 0º to 90º.
- Extendable from 87 to 145 cm.
- Maximun borne weight: 20 kg.
- Colour: silver.
- Dimensions: 4 x 5 cm arms and 4 x 8.5 cm arms, adjustable to the projector.
- Ceiling plate: 19 x 20 cm.
ASSEMBLY INSTRUCTIONS
CAUTION: make sure the surface the mount is going to be installed on is resistant enough and completely
flat.
ACCESSORIES INCLUDED
1.-

EN
- 3 -
2.- 3.-
4.- ATTACHING THE MOUNT TO THE PROJECTOR
Depending on the size of the projector, use the short arms M-L, the long arms N-M or a combination of
both as shown in the diagrams below.
5.- FIXING THE MOUNT TO THE INSTALLATION SURFACE

EN
- 4 -
6.-
ADJUSTING THE POSITION OF THE PROJECTOR
7.-

8.-
EN
- 5 -

IMPORTANT
1.- The surface to be installed on must be completely flat. Make sure the holes in the ceiling coincide with
the holes on the plate. Screw the mount to the ceiling.
2.- To adjust the direction of the mount, loosen the corresponding bolts the mount to the desired position
and tighten the bolts again. Never force the mount to move without loosening the bolts firt to avoid
breakages.
3.- Correct installation on the ceiling, or surface, is necessary to ensure that the mount supports the
maximum weight. FONESTAR does not hold itself responsible, in any way, for damage or breakages that
arise from the mount coming away from the surface due to a faulty surface, incorrect installation or
handling.
- 6 -
EN

WARRANTY
This product has been tested and has passed the corresponding quality control prior to being put on the market.
FONESTAR guarantees the suitability of the product for its specified use during a period of 2 years from the
delivery date and commits itself to repair or substitute the goods as expressed in the Spanish law ‘La Ley General
para la Defensa de los Consumidores y Usuarios, Real Decreto Legislativo 1/2007 16 Noviembre.
The lack of conformity in the first six months after purchase, due to a manufacturing defect, will be rectified with
no more than showing the proof of purchase. After six months FONESTAR reserves the right to demand proof of
the product being sold with that problem.
This warranty does not include damage produced by: inappropriate use or negligence, accidents, worn out parts
due to use, breakages, burns, spilt liquids or other substances, excessive humidity, battery deterioration and
internal manipulation of the device, the software or its components by unauthorized persons, and in general any
use that is unrelated to the nature and purpose of the product.
If any service is needed during the warranty period because of lack of conformity, please contact the business or
distributor where the product was purchased in no more than 2 months after being conscious of the problem. It
is only necessary to contact FONESTAR if it is impossible or imposes an undue burden for them to solve it.
To benefit from this warranty it is necessary to show the proof of purchase with the date clearly visible, with no
corrections or crossing out.
This document adds information, and never decreases the consumers’ rights, which in all cases are protected by
the Spanish law ‘La Ley General para la Defensa de los Consumidores y Usuarios, Real Decreto Legislativo 1/2007
16 Noviembre.
FONESTAR is a member of ECOEMBALAJES ESPAÑA, S.A. “ECOEMBES”, with number 03497 and all our products
carry the symbol, backed by our membership and subscription to the above mentioned organization with the recycling
and subsequent management of our packaging.
FONESTAR, S.A. - NIF: A28780443 - Polígono Trascueto - 39600 Revilla de Camargo, Cantabria (Spain)
www.fonestar.com
- 7 -
EN

www.fonestar.com