For-x XD-180.2 User manual

XD-180.2
Two-Channel Full Range Class D Amplifier
User’s Manual
Please read this manual thoroughly to before you install it.
Introduction:
Congratulations on your purchasing a high quality amplifier!
The amplifiers are manufactured with advanced craftsmanship and using the highest quality components and strict
quality control system. Thanks for your trust on FOR-X brand! Maintain your amplifier properly and it will ensure
you uncompromising musical enjoyment.
The FOR-X XD-180.2 class D amplifier is designed to revivify the high quality of the video in optimum sound systems.
It will display the high quality sound efficiently and reduce the dissipation to minimum.
Those RCA input can receive various of stereo signals and signals from CD/MP3 player also.
Read before installation
Please read this manual thoroughly. Below are the information which are very important for you to ensure you install
properly. If necessary, please contact with the after selling service department to solve the questions.
Please use high quality cables and keep them as short as possible, avoiding electrical disturbances and too hot.
The amplifier GND terminal should connect to the minus terminal of the battery directly .
Locate the position on the chassis o the car to which amplifier is to be ground.
To be safe, all cables should lay flat on the car chassis. Route the RCA cables away from other current carrying cables,
electronic power, auto ignition, key inject.
The +12 Volt power cable must be connected with a fuse in line within 30 cm from the battery +12 terminal, as show
in the attachment 02.
The install position is very import, it must be far from vibration source. It is better to install on top of speaker box. Do
not install it on module. Heating dissipation and air exhausting are very important to when install it on auto chassis.
Installation examples:
XD-180.2-1 SUBWOOFERS/4Ω(200W)

XD-180.2--2 WOOFERS/8Ω(200W)
XD-180.2--2 SPEAKERS/4Ω(200W)
XD--180.2—6 SPEAKERS /8Ω+ 2 TWEETERS/8Ω(200W)
Note: all above installation examples are as reference .In any installation, must follow the
smallest impedance. For more details please ask for our technical support.
Installation figure:
Battery
Remote
GND
OUTPUT: CHANNEL 1 , CHANNEL 2, CHANNEL 3, CHANNEL 4
Gain
RCA terminal
RCA end to the payer
Specification
Specification XD-180.2 Specification XD-180.2
RMS Power @12.6V 200W Channel 2x125 W RMS@2Ω
1x250 W RMS@4Ω
RMS Power @14.4V 300W Minimal consumption <0.1 A
Max Power PMPO 3000W Maximal consumption
(musical signal)
22A
Efficiency 95% Maximal consumption
(musical signal)
11A
Frequency Response 50 Hz to 20KHz Weight (kg) 0.3
Input sensitivity 0.5 to 6V Length (mm) 115
Voltage 12.6V(10V to 16 V) Width (mm) 100
Dumping Factor 400 Height (mm) 35
Distortion harmonic 0.01 %THD+N @60W SMD technology YES

Table 2
XD-180.2 CAPACITY
Battery 30A
External Fuse 30A
Power cable specification 6 mm²
Output cable specification 1.5 mm²
Important Notice:
If find any problem with the amplifier, before contact with the technical support, please try to find out the
reason according to below table:
Blinking
problem indicator
Low battery voltage
Load Short circuit or low impendence
If the problem can not solved, please contact the technical support center.