FORENO Primus PSL9 User manual

FORENO TAPWARE (NZ) LTD | Freephone: 0508 FORENO | [e-mail] | 5 Hewlett Street, Port Whangarei 0110 | FORENO.CO.NZ
9 421009 518067
Congratulations on your purchase of this high quality product from Foreno Tapware.
Please read the following before installation and retain (along with your receipt) for future reference.
TECHNICAL SPECIFICATIONS
Suitable for Mains Pressure only
Minimum Pressure = 150kPa
Maximum operating Pressure = 500kPa
Maximum operating Temperature = 65 deg. Celsius
For domestic use only.
CONFIGURATION
Mains Pressure systems Install as supplied.
Unequal Low Systems This product is not suitable for this type of water pressure.
Equal Low systems This product is not suitable for this type of water pressure.
CONTENTS
• Wall brackets and covers
• Fixing kit
• Glide bar with adjuster/holder
• 1.5m supply hose
• Supply elbow
• Shower handpiece
• Soap dish
INSTALLATION
See steps on the next page.
Then attach the supply elbow to the supply connection on the wall.
Primus
Multi Function Slide Shower
PSL9

FORENO TAPWARE (NZ) LTD | Freephone: 0508 FORENO | [e-mail] | 5 Hewlett Street, Port Whangarei 0110 | FORENO.CO.NZ
2
3
4
5
7
6
8
8
9
1
Max. 680mm
ATTACH PROOF OF PURCHASE HERE
WARRANTY
Please refer to our website for warranty information: www.foreno.co.nz/warranty
In the unlikely event that this product fails during its warranty period, phone our Customer Service team
immediately on 0508 FORENO (0508 367 366) – as unauthorised removal of the product may void the warranty.
CARE AND MAINTENANCE
Chrome-plated finishes should not be cleaned with astringent, abrasive or citric cleaners.
A so, damp cloth is recommended for cleaning. Mild soap solutions can also be used on occasion.
IMPORTANT:
If the installation is for Mains Pressure systems, then install
the flow restrictor between the supply elbow and shower hose
with the O ring in the disc facing out when fitted to the hose.
The bottom bracket can
be adjusted to desired height
1. Measure and mark hole position with pencil.
2. Drill mounting holes.
3. Push wall plugs into holes.
4. Place holder over top wall plug and fix in position with screw.
5. Attach soap dish to support, then slide onto the tube.
6. Slide the tube into holder then fit Holder B over tube.
7. Fix in place with screw (into wall plug B).
8. Clip holder covers on.
9. Attach hose to elbow and handpiece then insert
handpiece into holder.