Formax ColorMaxLP2 User manual

SET-UP/OPERATOR MANUAL
UNWINDER
7/2020
ColorMaxLP2
Digital Color Label Printer

The ColorMaxLP2 unwinder is used to unwind the labels on rolls with a ” internal diameter.
The maximum external roll diameter allowed is up to 250 mm (10”) while the maximum label width is
up to 240 mm (9.45”).
An external power supply 100/240VAC - 2.5A at 24V allows an electronic circuit to provide,
through the tension arm, the speed and sense of rotation auto adjustment.
INSTALLATION
STEP 1
Using the screws, install the outer disc on the
unwinder core holder.
STEP 2
Attach the printer plate to the unwinder. Do not
fasten the knobs for the moment.
STEP 3
Place the printer on the plate using the guide
rails.

STEP 6
Make sure to align the unwinder with the
printer.
Next, install the rewinder unit.
STEP 5
Push the media under the tension arm and
then feed it into the printer (look at the printer’s
manual how to load media).
STEP 4
Load the media roll and outside disk then tighten
the knob.