formera X2 User manual

V1.1
Package Contents
Quick Installation Guide
Power Adapter
IP Camera
1Hardware Introduction
Physical Description
Quick Installation Guide
Indoor Wireless FHD IP Camera
Hardware Installation
Model: X2
Wi-Fi Antenna
Mounting Bracket
Power light
Network light
I/O Alarm
Antenna
Power
LAN
Speaker
I / O Alarm LAN
DC 5V
Audio Output
Audio Input
Audio
OUT / IN
Microphone
LENS
Induction IC
PIR
SD Card
Slot
Reset/WPS Button Mounting Port
Network Light Status
Network Light Description
O No Wi-Fi connection
Flashing every 0.2 seconds EZLink takes eect (default)
Flashing every 0.4 seconds WPS is connecting
Slow Flash once per second Wi-Fi connected
Constant for 3 seconds Camera resetting
1. Screw the mount on the wall with the two screws
provided.
2. Loosen the thumb screws to adjust the mount to
the desired position. Once the position is set,
tighten the screws securely.
Quick Installation Guide
Indoor Wireless HD IP Camera
formera

4 FAQ
2Add the IP Camera 3Access the IP Camera
You can add the IP Camera by smart phone.
1. Download the App
You can go to the App Store or Google Play store and
search for “Formera Viewer”. Please download and
install it.
After your camera has been successfully added, you
can access the IP Camera via the app or browser.
2. Add the IP Camera
Run the app, then you can tap the "+" button on the
app and follow the setup wizard to add your camera.
The App icon will be displayed after successful
installation:
Formera Viewer
Please Note:
If you want to use your camera via the browser, you can
search and access its local website in LAN.
Please download the “Equipment Search Tool” le from
http://formera.net to your computer, run it to search
and access the IP Camera in LAN.
Forget Username / Password
Please Note:
After restore to factory default settings, you need to
cong the Wi-Fi connection again, you can follow
the Setup Wizard of the App to add again.
In case your device failed to add by Wi-Fi, you can
use WPS or wired connection. Please refer to the
User Manual downloadable on http://formera.net.
Restore camera back to factory settings:
1. Press "Reset" button for about 10 seconds with camera
powered on.
2. Release the button and wait about 30 seconds, the
camera will automatically restart, and restore factory
settings with its username / password recovery to
admin / (blank).
Before you continue, please note:
Make sure your smart phone has connected to the
wireless router, and your smart phone and camera
in the same in LAN(Local Area Network).
Do not use an Ethernet cable to connect the camera
if you want to use a wireless connection.
1. Install Wi-Fi antenna and position upright.
2. Connect the power adapter to the camera.
3. Connect the wireless router to the Internet.
Hardware Connection
IN OUT
I / O Alarm LAN
DC 5V
WPS