Forms + Surfaces CROSS TABLE User manual

CROSS TABLE
SURFACE MOUNT INSTALLATION INSTRUCTIONS
page 1 of 2 | Rev. 12-18-12
© 2012 Forms+Surfaces® | All dimensions are nominal. Specifications and pricing subject to change without notice. For the most current version of this document, please refer to our website at www.forms-surfaces.com.
T 800.451.0410 | www.forms-surfaces.com
TOOLS NEEDEDMATERIALS INCLUDED
STEP BY STEP
Attach table top to column
• Use drill with 1/2" nut driver (or socket
wrench with 1/2" socket) to attach table
top to column with 5/16"-18 x 3/4"
hex head bolts (a).
Mark hole locations
• Place table in desired location. Mark
center of each hole location with a pencil.
Drill holes
• Use hammer drill to drill 1-7/8" deep x
1/2" diameter anchor hole at each
marked location using a 1/2" drill bit
suitable for concrete drilling.
NOTE: Forms+Surfaces recommends
starting holes with 3/16" diameter drill
bit followed by 3/8" and finally 1/2" for
maximum accuracy.
abcd
FOR ALL SURFACE MOUNTED CROSS TABLES
steel
wire brush
hammer drill
pencil
hammer
1/4" punch
1/2" nut driver
a
7/32" hex bit for
tamper-resistant
screws
e
f
3/16", 3/8" & 1/2" drill
bits for concrete

CROSS TABLE
SURFACE MOUNT INSTALLATION INSTRUCTIONS
page 2 of 2 | Rev. 12-18-12
© 2012 Forms+Surfaces® | All dimensions are nominal. Specifications and pricing subject to change without notice. For the most current version of this document, please refer to our website at www.forms-surfaces.com.
T 800.451.0410 | www.forms-surfaces.com
Insert & set anchors
• Use compressed air and steel wire brush
to clean each anchor hole.
• Insert 3/8"-16 x 1-1/2” anchor (b) into
each anchor hole and use hammer to tap
anchor tops flush with ground level.
• Use 1/4" punch and hammer to set
anchors by driving down the center of
each anchor until it stops.
Position & attach table
• Position table so that mounting holes line
up with anchors.
• Slide 3/8" stainless steel lock washer (d),
then 3/8" stainless steel flat washer (e)
and 3/8" nylon flat washer (f) onto each
3/8"-16 x 1" tamper-resistant button
head cap screw (c).
• Insert screws into mounting holes in table
and thread into anchors using provided
7/32" hex bit for tamper-resistant
screws.
Tighten screws
• Tighten screws until snug.
STEP BY STEP FOR ALL SURFACE MOUNTED CROSS TABLES
b
d
e
f
c