Forms + Surfaces Knight Bollard User manual

KNIGHTTM BOLLARD
SECURITY CORE INSTALLATION INSTRUCTIONS
page 1 of 2 | Rev. 08-16-16
© 2016 Forms+Surfaces® | All dimensions are nominal. Specifications and pricing subject to change without notice. For the most current version of this document, please refer to our website at www.forms-surfaces.com.
T 800.451.0410 | www.forms-surfaces.com
TOOLS NEEDEDMATERIALS INCLUDED
STEP BY STEP
Create space for footer
• A sufficient footer size depends on frost
and other conditions to be determined by
the installer. A minimum of an
18" x 18" wide x 30" deep footer is
recommended.
Position and support security core
• Position security core in desired final
location and support so concrete can be
poured in hole around security core.
• The bottom of the base plate should be
level with the ground surface.
NOTE: The security core also serves as a
conduit path.
Pour concrete footer
• Mix concrete and pour footer according to
concrete manufacturer’s instructions.
• As soon as footer is poured, verify
levelness.
• Allow concrete to cure completely
according to concrete manufacturer’s
instructions before removing any
temporary supports or installing fixture.
NOTE: Security core will need to be free
of moisture prior to fixture installation.
FOR ALL KNIGHT SECURITY BOLLARDS
a
5/32" hex bit
WIDTH
DEPTH
BOTTOM OF
BASE PLATE
AT GROUND
LEVEL
level

KNIGHTTM BOLLARD
SECURITY CORE INSTALLATION INSTRUCTIONS
page 2 of 2 | Rev. 08-16-16
© 2016 Forms+Surfaces® | All dimensions are nominal. Specifications and pricing subject to change without notice. For the most current version of this document, please refer to our website at www.forms-surfaces.com.
T 800.451.0410 | www.forms-surfaces.com
Position bollard over security core
• Inspect security core for moisture. If
moisture is present remove and dry
immediately before installing fixture. Do
not install fixture unless security core is
completely dry.
• Slide bollard over security core so lower
holes in bollard line up with holes in
security core base plate.
STEP BY STEP FOR ALL KNIGHT SECURITY BOLLARDS
Attach bollard to security core
• Thread 1/4"-20 x 3/4" flat head cap
screw (a) into each lower hole in bollard.
• Use 5/32" hex bit or key to tighten all
screws until snug.
a a
a