Fosi Audio DAC-Q6 User manual

Fosi Audio DAC-Q6 User Manual
Before using this product, please be sure to read carefully this instruction manual
and keep it safe for further reference

Front-end interface function description
Thank you very much for choosing our products! Please read this
manual carefully before using the product.
back interface function specification
DAC-Q6
HEADPHONE
M0DE

44 1 KHz
Bluetooth antenna interface
1
PC-USB input jack
2
Optical input jack
3
COAXIAL IMPUT
4
AMALOG RCA output jack
5
POWER(DC power cann’t beyond 12V)
6
Display
1
1
RF PC-USB OPTICAL
AUDIO IN
COAXIAL R L
MADE IN CHINA
DC 12V
AUDIO OUT
1 2 3 4 5 6
23
6.35 headphone output jack
2
ON/OFF/input mode selection key
VOL+/-(short press switch, again
short press select input channel,
long press switch it off,increase clockwise
and decrease counterclockwis)
3

Operation steps:
1. Make sure the VOL turnto the minimum.
2. Connect the external back-end equipment to the output
interface of sound source.
3. Connect the sound source that needs to be used.
4. To select bluetooth mode, you need to switch the input
channel to bluetooth mode for pairing connection.
5. Connect to power.
6. short press switch, again short press select input channel，
long press switch it off.
7. signal (coaxial/optional/pc-usb/bluetooth).
8. Turn the VOL button clockwise to select the desired volume.
9. The RCA analog output will automatically disconnect when
connected to the headset output, such as the headset.
10. After use, press and hold for 3 seconds to shut down.
PC driver installation method
1.ASIO Driver installation:
Double click on the ASIOProxyInstall-0.6.5, Then follow the
prompts to install.

2.The sycon driver installation:
Double click on the SUCA_UsbAudio_v4.80.0_2019-12-09_setup，
Then follow the prompts to install.

After open the foobar200, click Top left File,choose Prefereces,
Click Components, Click again Install.

3.Foobar The installation:
folder Foobar It is free of installation, Double click open foobar2000
After open the foobar200, click Top left File, choose Prefereces,
Click Components, Click again Install.
After installation, open the driver and the following dialog box
appears.

At the same time selectedfoo_input_sacd.fb2k-component、
foo_out_asio.fb2k-component、WASAPI.fb2k-component Click
open after three files.
Select the following three files, Click again open
Click Apply
Click OK
Open
Click again sure
Cancel

Open foobar2000, Click Library choose Configuer Click again
output.

PC-USB Operation Instructinos:
1. Connect the PC-USB interface of the rear surface of the
machine with factory provided USB cable (USB can support
hot plug).
2. Press the input signal selection switch to select USB input.
3. The following photo shows the icon with horn symbol in the
lower right corner of PC.
4. Right click to pop up the dialog box and click <choose play
device>.
5. Select the playback device recognized by PC in the pop-up
dialog box(XMOS…).
6. Click to confirm the identified digital output.
A………Input channel display area, display separately according
to selection USB/BT/ Coaxial /Optical
B………Input sampling rate display area, no signal displayed
C………Volume display area，Volume 0-99
D………The bottom is the volume progress bar
OLED Show: