Reaper Extreme
VTX
1. Size: 36*27.5*8mm
2. Connector: MMCX
3. Display: 3LED
4. Weight: 13g
5. Power: 25mW/200mW/500mW/1.5W/2.5W
6. Input: 9~36V
7. Output: 5V
8. Channel: 40CH
9. Protocol: Tramp
Spec:
4. Unlock the frequencies and power levels
Long press the "KEY" button until the Red LED (PWR) is
constant on, off, then on again, release the button unlock
the all frequencies and power levels, flashed Red LED means
in unlocked status, constant Red LED means in locked status.
5. PIT Mode On/Off
Double-click the "KEY" button to turn on/off the PIT Mode.
Red LED (PWR) off means PIT mode on; Red LED (PWR) on
means PIT mode off。In PIT mode, VTx outpout extreme low
power.
2. Button Operation
Channel select mode:
Short click, enter CHANNEL setup, only green light is on and
flash, select channel by short presses.
Power select mode:
Continue to press the button for 3s, enter POWER setup, RED
LED is on and flash, select power by simple short presses.
Band select mode:
Continue topress the button for 3s, enter BAND setup, blue
LED on and flash, select band by short click.
1. LED
Description
PowerRed
Band
ChannelGreen
Blue
LED
3. Frequency Table
* Black parts are locked by default.
5865
5733
5705
5740
5658
CH1
5845
5752
5685
5760
5695
CH2
5825
5771
5665
5780
5732
CH3
5805
5790
5645
5800
5769
CH4
5785
5809
5885
5820
5806
CH5
5765
5828
5905
5840
5843
CH6
5745
5847
5925
5860
5880
CH7
5725
5866
5945
5880
5917
CH8
Band A
Band B
Band E
Band F
Channel
Race
Band
Power
(mW) PIT 25 200 500 1.5W 2.5W
If tramp cable is connected, button will not work, can not
adjust frequency and power, controller will take over.
Notes:
