Franklin 30129X User manual

Net Assembly Instructions
1. Using 4 self-stick closure straps, 2 for each corner on the
top bar, tie the top right and top left corners, identied by the
two RED tabs.
2. Using 4 self-stick closure straps, 2 for each corner on the
lower front bar, tie the lower right and lower left corners
identied by the two BLUE tabs.
3. Stretch the net and using 4 self-stick closure straps tie 2 each to the
back bottom corners.
4. Fill in the top front section with 8 self-stick straps.
5. Fill in the two side sections with 6 self-stick straps.
6. Fill in the bottom back section with 8 self-stick straps.
NOTE: Adjust the self-stick straps by moving the straps left or
right as necessary to prevent large gaps.
NOTE: Following goal assembly, 6 ground stakes will help secure
the goal. Two are recommended placed over each side/base tubes,
right side and left side near the front. Two are recommended placed
over the back/base tubes.
The net has been designed with red tabs to identify the top
corners and blue tabs to identify the bottom front corners.
Follow the numbered sequence to attach the net.
Franklin Sports Inc.
Stoughton, MA 02072
Made in China
For replacement parts call:
1-781-341-5178 or 1-800-225-8649
OR visit www.franklinsports.com
BEFORE ASSEMBLY:
Work on a smooth, at surface.
Lay out all components so they are in easy reach.
Read assembly instructions completely to familiarize
yourself with the components before you begin assembly.
This goal is designed to provide many hours of
enjoyment if properly assembled and used only
for the purpose intended.
Adult supervision is recommended when the goal
is used by children.
FOLDING SOCCER GOAL
SIZE: 6ft High x 12ft Wide
(1.83m x 3.65m)
NO. 30129X

L Shaped Bent Tube 4pcs
Straight Double 2pcs
Flanged Tube
Folding Corner Piece, Left 1pcs
Folding Corner Piece, Right 1pcs
Straight Double 4pc
Long Straight Double 2pc
Flanged Tube
Ground Stakes 6pcs
Pin 2pcs
Screw (Pre-assembled) 2pcs
Bolt (Pre-assembled) 2pcs
Net 1pc
Self-Stick Straps 40pcs
FRAME COMPONENTS
1
2
5
4
3
6
7
8
9
10
Assembly Instructions
1. Assemble top front cross bar and back base bar by inserting tube marked
into the tube . Then insert tube into tube . Lastly insert tube
into another tube marked . Do this once for the back base and again
for the front cross bar.
2. Insert the remaining 2 pieces of tube into the bent ends of tube on
each side of the back base.
3. Connect the folding joint part to the end of tube and attach folding
joint to the other part on the side base.
4. Insert tube into tubes and on both ends of the structure.
5. Attach the top front crossbar (assembled in step 1) to the upward pointing
tubes marked .
6. To fold goal (refer to gure 1B) remove the lock pin on both sides before
folding top backwards. Once folded, insdert lock pins to secure.
11
12
FRAME ASSEMBLY
Assemble all lengths of tubing as shown in Figure 1. Be sure that
each piece is inserted completely. The end of each tube inserts
tightly and is secured when the press button of the tapered end
pops through the adjoining perforated tube. (Refer to Figure 1A)
5
Figure 1A
Figure 1B
2
4
3
6
3
Figure 1
4
5
6
6
5
5
25
51
5
5
5
6
1
1
3
8
8