Franklin MLB DELUXE RETURN TRAINER User manual

WARNING: Use extreme caution when assembling the net to the frame. The bungee
cords are under extreme tension and must be attached carefully. Eye protection is strongly
recommended during assembly.
0[LT5V
43)+,3<?,
9,;<95;9(05,9
(::,4)3@05:;9<*;065:
(+<3;(::,4)3@9,8<09,+
Step 9:
Attach target ribbon by weaving through net and tying o at ends.
Step 7:
Line up holes on (3) and (7) and attach with buttery screw. Repeat with (3) and (6).
Step 8:
Tighten“Innite Angle”adjustment system. Spread out net and nd red corner markers. Use
bungees to attach corners rst. Then attach the remaining bungees in the following order: 4
on top, 6 on left, 4 on bottom, and 6 on right, spread evenly on each side. To attach bungees to
net, hold plastic ball in place and wrap free end around net, steel frame, and nally back
around plastic ball.
Step 6:
Assemble (11) to (10). Center (13) on (1) and attach (12) to (13).
Step 5:
Complete bottom frame by attaching (7) to (1) to (9) and (6) to (1) to (8).
Franklin Sports Inc.
Stoughton, MA 02072
Made in China
For replacements parts call
1-781-341-5178 or 1-800-225-8649
OR visit www.franklinsports.com
Ribbon
Attachment
Bungee
Attachment
12
98
7
6
1
13
1
11
10

Replacement Parts
Part
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
Amount
4
2
2
2
2
1
1
1
1
1
1
1
1
24
2
1
1
4
Description
Male-to-Male Straight Tube
Female-to-Female Top Elbow Tube
F/F Bottom Elbow Tube
M/F Top Straight Tube
M/M Bottom Straight Tube
Rear T-Joint
Top T-Joint
Toothed Bungees
Buttery screws
Net
Target Ribbon
Ground Stakes
Pa
r
t
Am
ou
n
t
D
escription
Step 1:
Slide (13) through (1). Make “U” shape by attaching (2) on both sides of (1).
Step 2:
Make “U” by attaching (3) to both sides of another (1).
Step 3:
Combine top“U” with bottom “U” using (4) and (5). Line up two holes on bottom of (5) with
two holes on (3). Set aside frame.
ASSEMBLY INSTRUCTIONS
Step 4:
With (10) slot facing forward, slide (10) onto (9). Line up (9) hole with (10) slot. Attach (8) with
push pin to (9) hole. Push pin will end up in (10) slot.
Side L-Tubes (L&R)
Rear L-Tubes (L&R)
Adjustable Tubes
1069
1069Z1
1069Z2
1069Z3
1069Z4
1069Z5
1069Z8
1069Z10
1069Z11
1069Z12
1069Z13
2778Z7
2738Z3
1069Z6
1069Z7
1069Z9
12
44
2
12
11
5
5
10
9
8
7
3
36
13
15
15
14
16
17
18
1
1
9
8
12
44
5
5
3
3
13
1
2
10
1