freecam C330 User manual

1. Download “Doby” from App store for
iPhone or Play store for Android phone.
•Make sure your smartphone is
connected to the Wi-Fi router.
•Register to create an account and log in.
•Open the app and “Click “+” button on
the bottom right corner to add camera.”
2. Turn on the power switch after
removing the safety cover.
•Blue LED light should be blinking.
•If not, press and hold the WiFi key for
about 5 seconds until the WiFi indicator
blue light is blinking.
3. While WiFi LED is blinking.
•Tap [Yes] to enter WiFi setup page.
•Tap on the searched camera.
•Enter WIFI Password.
More detailed instruction, Visit our support site For video demonstration. www.solocameras.com
For tech support, email us at [email protected]om Or, call 201-934-1654.
1. Download App 2. Turn on the Power
3. One Key WiFi Setup 4. Live View
4. Tap on the camera from the list.
•Tap to play live view.
•Tap on Protection for alarm setting
•Tap on Playback to see recorded
video.
C330 Quick Setup Guide
Micro SD
card slot
Power
Switch
WiFi Key

1. Please make sure all parts are included.
•WiFi Camera with built-in battery
•Mounting Wall Bracket
•3 x wall screws & 3 x expansion screw set
•USB Cable & Power Adapter
•1 x mounting screw &
1 x plastic gasket
2. Fully charge your camera before use.
•Connect the power cable to camera.
•For initial charging, the camera must be
fully charged which takes about 4 hours.
•Turn on the power switch.
•The yellow LED light will be on to indicate
that the battery is charged.
For more detailed instruction, Visit our support site For video demonstration. www.solocameras.com.
For tech support, email us at [email protected]om Or, call 201-934-1654.
1. Content & Parts 2. Charging Camera
3. Bracket Assembly 4. Wall Mount Installation
C330 Installation Guide
Parts & Description
4.1. Drill holes on the
wall and insert green
expansion screws into
the holes.
4.2. Remove screw
cover and unscrew to
detach the camera
mounting base.
3.1. Insert the clear
plastic washer into
camera mounting screw.
4.3. Align the holes of
the mounting bracket
with the expansion
screws and secure the
bracket.
3.2. Set the mounting
screw into bracket.
3.3. Tighten the mounting
screw and adjust bracket
angle to finish bracket
assembly
4.4. Screw back the
camera base. Adjust
bracket angle to a
desired position.
2
3.4. If necessary, peel off
the sticker from bottom
of the mounting bracket
to stabilize the camera.