Freshtel Netcomm V100 Quick guide

Netcomm V100
Configuration Instructions
Step 1: Connect your V100
1. Phone – plug in your analog telephone cord.
2. Ethernet Port - use an Ethernet cable to connect your V100 to your router or modem.
3. Power connection - Connect the power to your V100.
4. See your Netcomm V100 User Manual for more connection options.
Step 2: Install the V100 Software Utility.
1. f you have not already done so, install the V100 PC Tool utility on your PC. This would
have come on a CD with your V100, and can also be downloaded from the Netcomm
website:
http://www.netcomm.com.au/Support/downloads.php?Category=Vo P&Products=V100
2. Run the V100 PC Tools Application

Step 3: Configure the V100 T
1. You will need to know your Firefly Number and Password.
2. Click on the S P tab, then select the Local tab from the below row. Set it up as follows
(be sure to use your own Firefly Number and password!):

3. Click on the STUN tab and set it up as follows:
4. Click on the Apply button.
5. Click on the Close button.
6. Your Netcomm V100 is now configured and ready to use the Firefly Network. Simply
pick up the phone and dial!

Dialling:
To dial a Firefly number or voicemail, prefix the number with a star, e.g. *80001234, *123.
f you have configured a local dialling prefix for your account via the Freshtel website , you
can dial local, national, mobile, and international PSTN numbers exactly as you would from a
land line phone in your area; e.g. 08007654321 (US), 9557745 (US – local), 0061399156415
(UK – international), 99156415 (Australia – local).
f you have not configured a local dialling prefix, numbers are dialled in full (including country
code but without any international dial prefix), e.g. 61399156415, 18007654321. Land lines
and mobiles in Australia can be dialled with an initial 0, e.g. 0399156415.