Frigidaire FLBY06GGAWFD User manual

FLBY06GGAWFD
FLBY06GGAWF
Electrolux Major Appliances International,
10200 David Taylor Drive, Charlotte, NC 28262, USA
Made in china

Features:
Spiral strong water flow,wash more clean.
New wash mode,remove the dirt on the clothes thoroughly.
Multi water level indication,save water and energy.
Rinse and foam-removing spinning,clean and fast.
BEFORE USINGBEFORE USING
8
8
8
Using process
Washing attentions .......................5
Use of detergent............................5
Washing sequence........................6
After using..................................8
Clean lint filter..............................
Clean machine..............................
When the remained water is frozen..
Trouble-shooting...........................9
Content
Before using
Name of part.............................1
Attention ..................................2
Installation and adjustment ........3
Main functions ..........................4
Preparation before washing........4
SPIN TUB INNER COVER
CONTROL PANEL
WASH TIMER
WASHING WATER INLET
WASH TUB
LINT FILTER
PULSATOR
OUTER CASE
PLASTIC BASE
SPIN TUB
POWER CORD
DRAIN HOSE
SPIN TUB COVER
SPIN TIMER
PROGRAM SELECTOR
SAFETY COVER
1
WASH TUB COVER
SPINNING WATER INLET
If the picture of washing machine here is different from the real products,we are not going to change it.
WATER INLET HOSE

2
Don't put it at damp place, like bathroom.
Never clean it with water.
Don't put the wet clothes on the control panel.
The water over 50 is forbidden.
Don't put your hand into the spin or wash
tub while it is working even though it runs
very slowly, especially take care of the
children.
Don't separate it apart, repair or refit it by
yourself.
Don't put any hot or heavy object on the
machine.
The clothes with the volatile
materials(such as thinner,fuel) is forbidden
to wash.
The children without care or the
handicapped are forbidden to use.
Keep the machine away from direct
sunlight and heat source like the heater.
ATTENTION BEFORE USINGBEFORE USING
Use 3-phase socket,the
earthing should be well
connected.
Pull out the plug while no
power, move no use or
cleaning.
If the wire is destroyed,
for safe, please ask our
after -sale service
technician to change or
repair it. Keep the pins
of the plug clean.
50 C

3
INSTALLATION
Using the drain hose
Factory installation position of the drain
hose is shown in Figure 1.
The hose protrudes out from the washing
tub side.
Lay down the machine. And take the hose
out from the fixing groove. (Figure 2)
Insert the hose in the groove by hand, do
not damage the hose.
Along with the groove of the washing tub
side, insert the hose with steps 1 to 3 and
spread it to the washing side. (Figure 3)
Change the direction of the drain hose
Please install your washing machine according to the instructions provided.
Figure 1
Figure 2
Figure 3
Soft object
Back
Front
Soft object
Drain
2. Maximum fixation height for hanging the
hose(with a hook)over a drain outlet(eg.drain
pipe,bath or sink)should not be higher than
1.2metres above the floor(This is for pump drain
model only).
3. Do not trample or press the hose.
.
10cm
The hose should drain smoothly
1. The fixation heig t of the hose should be less
than 10cm from the ground.
h

4
MAIN FUNCTIONS
BEFORE USINGBEFORE USING
The comprehensive performance of the machine is excellent and its appearance is nice .
As to the noise-proof design, the machine uses the enclosed base and low-noise motor
which can lower the noise greatly. We assure you will have a quiet world when use it.
2.It can remove the extra
detergent liquid and save
time and water.
Hand washing can
improve the washing
ability.
1.Rinse and foam-
removing spinning 2.Hand washing
Preparation before washing
Attention before washing
Be sure of the special request of the
clothes.
Take coins, sand and
hairpins out of the
clothes
Fasten the buttons and
the zippers.
When the pulsator is
running, the buttons may
cause sound. For safe, put
the clothes with button in
the middle of the cloth.
The quantity of the Clothes
should not exceed the
rated value.The big clothes
like jeans should be put in
loosely.
1.Install the inlet hose. The max water pressure
permitted is 0.6MPa,the min is 0.03MPa.
2.Be sure the earthing is ok and insert the plug. And
the earthing should not join with gas pipe or water
hose.
3.Lay down the drain hose.(Down drain)
4.Put up the drain hose.(Up drain)
5.Please keep machine level, otherwise it will cause
an abnormal sound.

5
WASHING ATTENTIONS
USING PROCESSUSING PROCESS
Reference weight
How to use the bleacher
Fill the water to the specified level, and pour the bleacher into wash tub.
The colourful clothes are apt to fade, so the bleacher is forbidden to use.
The bleacher should not contact with clothes directly.
The use of bleacher, refers to its instruction.
The powder bleacher can be used after dissolved.
How to use washing powder
he rated capacity of washing , spinning refers to the max weight of the dry
clothes. The weight of the clothes to be washed should be below the rated capacity.
The capacity will be affected by the thickness, size and type of the clothes.
If the weight of the clothes is below 2kg,do not select the high water level, so as
to prevent splashing of water.
T
Dissolved in the tub
1.Fill small quantity of water..
2.Add some washing powder run for 30 seconds to dissolve it completely.
3.Put the clothes in and select the proper water level.
Quick dissolving
1.prepare warm water of 30 and a container.
2.put the powder in and stir.
The powder is more prone to pollute the clothes than the detergent,therefore please
use it with proper quantity.
For different powder, the dosage is different.
Work
clothes
(1120g)
Pajamas
(200g) Shirt
(300g)
Undershirt
(180g)
Blanket
(900g)
Sock
(50g)
Underwear
(70g) Jacket
(800g)
Coat
(800g)
Jeans
(800g)
Bedsheet
(600g)
USE OF DETERGENT

Wash Timer
Off
Normal
Strong
Drain
Wash Selector
0
Off
Spin Timer
6
WASHING SEQUENCE USING PROCESSUSING PROCESS
1.Put the clothes into the spin tub smoothly.
2.Spin.
(1)Press the safety cover properly.
Even though a few clothes, press the cover
too.
(2)Close the spin cover .
(3)Spin for 1- 2 minutes.
3.Rinse and foam-removing spinning
(1)Open the spin cover.
(2)Put the inlet hose into the spin inlet and
fill water for1 m inute.
(3)Close the cover, spin for 1-2 minutes.
Midway spinning
Wash timer Spin timer
2.Fill the water
and add
dissolved
washing powder
to the specified
level
3.Put in the clothes,
Please add the water if
the water is not enough
4.Select
the
program
according
to the
clothes.
5.Select
the wash
time
according
to clothes.
6.After
washing,
set the
selector
to the
"drain".
1. Put the water inlet hose
into the wash inlet
Program selector
Wash inlet Spin inlet
Wash Timer
Off Normal
Strong
Drain
Normal
Strong
Drain

7
WASHING SEQUENCE USING PROCESSUSING PROCESS
Rinse(filling water)
1.Put clothes in the washing tub and select the suitable water flow according
to the clothes.
2.Fill water to the specified level.
3.Rinse
Adjust the wash timer to 2-3 minutes to do rinsing.
When the weight of clothes is below 3kg, use standard water flow. If you use
the strong water flow,it may make water splash.
1.Put clothes in the wash tub and select the suitable water flow according to
the clothes.
2.Rinse
Adjust the wash timer to 5-7minutes to do rinsing.
Rinse with water(Repeat the midway spinning and rinse for 2-3 times.)
Spinning
1.Put the clothes in spin tub smoothly.
2.Press the safety cover properly and close the
spin cover
3.Spinning
Select the spin time according to clothes and
do spinning.
While spinning, there may be abnormal sound.
It is because clothes are not put properly,
please switch it off, and arrange the clothes
again.
While spinning,open spin cover, spinning will
stop; Close it, it will resume the spinning.
Clothes Spin time(m)
Bedsheet, blanket
Underwear(knitwear)
Sweater(fabric)
Thin clothes
About4~5
About2~4
About1~2
Within 1
Selection of spin time
Rinsing
To do spinning and draining or rinsing(filling water) together,please
first do spinning for about 1 minute,then do draining or rinsing,
otherwise the spinning will stop owing to too much water stored in the
spin tub.

8
AFTER USING
After washing, clean the lint and foreign objects on the lint filter and the frame, or
it will affect the next use.
Before cleaning, pull the plug out.
During washing,the lint-filter must
be used.
Be sure to clean it after use.
1.Take the filter down.
Put your hand on the groove, press
it and take it down.
2.Cleaning
When the lint is wet, put it into the
water and clean.
3.Install the filter
After cleaning, insert the filter into
the frame, and press in its upper part.
Clean lint filter
Clean the machine
Clean machine with soft cloth.
Clean with neutral detergent if is too dirty.
Never wash it directly with water.
After washing, take off the water inlet hose.
Pull out the plug, hang up the wire.
Do not keep water in wash tub for a long time.
After washing, drain immediately.
Clean the outside and inside of the machine with
soft cloth. Open upper cover and close it again
after 1 hour .
Hang up the drain hose well.
When the remained water is frozen
Prevent the freezing(after washing, drain water
completely)
After complete draining,set the program/drain
selector to the strong or standard position.
If it is on the drain position, ice is hard to melt
When the water is frozen.
Pour water below 50 degree into wash tub to
soak.Then turn the pulsator with your hands
gently until it can drain, After that,you can use it
again.
C
2-3 L

9
Problem Reason
TROUBLE-SHOOTING
The machine does not work
Power failure
Machine is not plugged in and powered up.
Pulsator is clogged
The draining does not work
Drain hose is not kept down.
Drain hose is frozen.
Drain hose is blocked.
Clothes outside spin tub.
Abnormal noise during
washing
There are hairpins, coins, or metal items in
wash tub
Abnormal noise and violent
vibration during spinning
Machine is not level.
Safety cover not properly placed.
Clothes are outside spinning tub.
Amount of clothes beyond stated capacity.
Water flows from the drain
hose during first use
It is the water remained from factory
inspection of performance.
WARNING
3.This appliance is not intended for use by persons(including children) with reduced
physical,sensory or mental capabilities or lack of experience and knowledge,unless
they have been given supervision or instruction concerning use of the appliance by
a person responsible for their safety.
4.Children should be supervised to ensure that they do not play with the appliance.
1.If the supply cord is damage,it must be replaced by the manufacturer
or its service agent or similarly qualified persons in order to avoid a hazard.
2.For washing machine with ventilation openings in the base,that a carpet
must not obstruct the opening.
NOTE
1.Maximum pressure allowed at the water inlet:0.6MPa.
3.The new hose-sets supplied with the appliance are to be used and that old hose-sets
should not be reused.
2.Minimum pressure allowed at the water inlet:0.03MPa.