Frigidaire FWS545RF User manual

Versión en español
Si desea obtener una copia en español de estas
Instrucciones de Funcionamiento, sírvase escribir a la
dirección que se incluye a continuación. Solicite la
P/N131722100.
Spanish Owner's Guides
Frigidaire Company
P. O. Box 9061
Dublin, Ohio 43017-0961
2. Prepare items for washing.
3. Pretreat stains and heavy soil.
4. Add the measured amount of detergent to the
washer before adding the laundry load.
5. If desired, add liquid bleach to the Bleach
Dispenser.
6. Add the laundry load to the wash tub.
7. If desired, add liquid fabric softener to the Fabric
Softener Dispenser.
8. Set washer controls according to type, size, and
soil level of each load:
Wash/Rinse Temperature
Agitate/Spin Speed
Load Size
See Controls and the Control Settings Chart (reverse
side) for more information on suggested water
temperatures, agitate/spin speeds, and water level.
9. Push in the cycle selector knob and turn it
clockwise to the desired wash cycle. See Cycle
Selection for cycle descriptions and the Control
Settings Chart for suggested cycle settings.
10. Start the washer by closing the lid and pulling
out the cycle selector knob. The washer will
operate with the lid open; however, the tub will not
spin unless the lid is closed. To stop the washer,
push in the cycle selector knob. To change a cycle,
push in the cycle selector knob and turn it clockwise
to the desired setting. Pull out the knob to restart
washer.
11. Remove items when the cycle is completed. A s
a safety measure, the lid will AUTOMATICALLY
LOCK during the spin portion of each cycle. The lid
will automatically unlock approximately 1 minute
after the tub stops spinning.
Cycle Selection
For best results, follow the fabric care label directions on
items to be washed. Check the Control Settings Chart
if the care label is not available.
The Regular, Perm Press and Knits & Delicates cycles
provide a spray rinse during the first spin, followed by a
deep rinse and a final spin.
Regular Cycle
Up to 15 minutes of wash agitation for most fabrics.
(continued, reverse side)
P/N 131722000 (9711)
OPERAOPERA
OPERAOPERA
OPERATING INSTRUCTIONSTING INSTRUCTIONS
TING INSTRUCTIONSTING INSTRUCTIONS
TING INSTRUCTIONS FWS545RFFWS545RF
FWS545RFFWS545RF
FWS545RF
Before Operating Your Washer
ReadyourwasherOwner'sGuide.Itcontains important
safety and warranty information. It also contains many
suggestions for obtaining the best results from your
washer.
To reduce the risk of fire, electric shock,
or injury to persons, read the IMPORTANT SAFETY
INSTRUCTIONS in your washer Owner's Guide before
operating this appliance.
Operating Steps
1. Sort laundry into loads that can be washed
together.
Printed in U. S. A.
All manuals and user guides at all-guides.com
all-guides.com

Fabric Type
REGULAR
Heavily Soiled
Colorfast & White
Cotton & Linen
Normally Soiled
Colorfast & White
Cotton & Linen
Lightly Soiled
Noncolorfast
Bright Colors
All Fabrics
PERMANENT PRESS
White or
Heavily Soiled
Colored or
Lightly Soiled
KNITS/DELICATES
Knitted Fabrics
Delicates
Washable Woolens
Locate fabric type and read across guide for suggested wash and rinse temperatures, wash cycle and time setting,
and agitate/spin speeds. This is only a general guide. For best results, follow label directions on specific items
to be washed.
Control Settings Chart
Agitate/Spin Speed
Normal/Fast
Normal/Fast
Normal/Fast
Normal/Slow
Normal/Slow
Gentle/Fast
Gentle/Slow
Gentle/Fast
Wash Cycle and Setting
Regular - 15
Regular - 8 to 12
Regular - 4 to 8
Perm Press - 8 to 12
Perm Press - 4 to 8
Knits & Delicates - 6
Knits & Delicates - 6
Knits & Delicates - 6
P/N 131722000 (9711)
Temperature (Wash/Rinse)
Hot Cold
Warm Cold
Cold Cold
Hot or
Warm Cold
Warm
or Cold Cold
Cold Cold
Cold Cold
Warm Warm
AGITATE/SPIN SPEED determines speeds for the
agitation and spin portions of each cycle.
LOAD SIZE determines the amount of wash and rinse
water used for the wash load. To increase the water
level after the wash cycle begins, turn the Load Size
control to Reset and hold. When water begins to enter
the tub, turn the control to the desired setting.
Cycle Selection (continued)
Perm Press Cycle
Up to 12 minutes of wash agitation for cottons and
blends with a no-iron finish.
Knits & Delicates Cycle
Six minutes of wash agitation for the gentle care of knit
and delicate items.
Soak & Prewash Cycle
•Soak — The Soak setting can be used to treat heavily
soiled or stained items. It provides 2 minutes of
agitation and 12 minutes of soaking time, then
advances to the Prewash portion of the cycle. Use
the amount of detergent recommended for a normal
wash cycle. For colorfast items, bleach or a soaking
agent may also be used. Follow manufacturer's
directions on the product label.
• Prewash — When soaking is not necessary, the
Prewash setting can be used alone to help remove
protein-based stains such as milk, grass and blood
and to help loosen soils before washing. During
Prewash, the washer will agitate the load for 2
minutes, then drain, spin and shut off. Use the
amount of detergent and other laundry products
recommended for a normal wash cycle.
Note:
• The Soak water temperature is the same as the
rinse water temperature selected; the Prewash
water temperature is the same as the wash water
temperature selected. To avoid setting protein
stains, select cold water.
• Select wash/spin speeds appropriate for the items
being soaked or prewashed.
• Soak and Prewash should always be followed by
a complete wash cycle using the recommended
amount of detergent.
Controls
Select the desired control settings according to load size,
fabric type and degree of soiling. See Control Settings
Chart below or Washing Procedures in your Owner's
Guide for detailed information on choosing control
settings.
WASH/RINSE TEMPERATURE determines water
temperatures for washing and rinsing.
All manuals and user guides at all-guides.com