Frontgate 154855 User manual

Lotus Fountain
ASSEMBLY INSTRUCTIONS
(please also see photos on 2nd page)
1. Determine location for fountain and make sure area is level.
2. Pump and hose assembly must be done before placing fountain against the wall.
3. Unpack pump, attach the suction cups to its feet, place rubber ring / gasket over the threaded adaptor
and screw it into threaded hole at the top of pump (photo A).
4. The accessories bag including 4pcs screws / 1 set of flexible hose with flow rate control valve /
1 pc round steel cover / 1pc spanner, (photo B)
5. Adjust flow rate to achieve the desired effect and to minimize any splashing, Splashing can
occur if the flow rate is too high or the reservoir is too full. The flow rate can be increased or
decreased by moving the flow rate control valve on the flexible hose . Moving the valve
clockwise, will increase the flow rate and moving counterclockwise will decrease it.(photo C)
6.Connect the long flexible hoses with top fountain (photo D )
7. Take out the pump plug from outlet of bottom fountain(photo E)
8.Connect the pump with the short flexible hose (photo F)
9. Place the top fountain onto the bottom (photo G)
10.Lock 4 screws on the corners on the bottom fountain by spanner (photo H)
11. Fill the reservoir at least 85% full with clear / cool water. Always make sure the water can
submerge the pump completely to work properly and prevent the pump damage.
and put the round steel cover. (photo I)
12.Turn the switch on and the water will start to flow in minutes.

Pump (mounted) - A
accessories - B
Flow control valve- C
Hose connect top fountain- D
Take pump plug out from outlet- E
Connect pump with hose- F
Place top fountain onto bottom- G
Lock screw by spanner - H
Fill
reservoir
with water,place
round steel cover on bottom- I
Frontgate: Please contact one of our Product Specialists for assembly
assistance or questions at 1-800-537-8484 or email [e-mail].
Specialists are available weekdays 8:00 a.m. to 8:00 p.m. EST or Saturday
9:30 a.m. to 6:00 p.m.

REGULAR CARE AND MAINTENANCE
GENERAL FOUNTAIN INSTRUCTIONS
Fountains are frost-resistant up to -4°F (-20°C) but pump must be removed from fountain during freezing
temperatures. If fountain must be left outside and temperatures drop below -4°F (-20°C):
(1) Remove pump for storage indoors.
(2) Raise fountain base from ground with wood strips so that base will not freeze to the ground surface.
(3) Cover or wrap the fountain with burlap or other absorbent material (old blanket or towel) and then
cover securely with plastic, making sure that water will not accumulate in the basin or other fountain
component and freeze.
(4) Check fountain periodically to insure that plastic is secure and water is not accumulating in any fountain
component.
- G E N E R A L F O U N T A I N T I P S –
Install fountains on a level surface. You will need a properly grounded 110-volt (AC only) GFCI protected
receptacle near the fountain for your pump. Test all pumps and adjust to full output prior to assembly. It is
not recommended that fountains be placed directly on grass or dirt.
Frontgate: Please contact one of our Product Specialists for assembly assistance or questions at:
1-800-537-8484 or email [e-mail].
Specialists are available weekdays 8:00 a.m. to 8:00 p.m. EST or Saturday 9:30 a.m. to 6:00 p.m.