Item:F-IH-01SS
Power Rate: 1800W
Voltage:120V/60Hz
HOW TO USEⅢ
1. Before turning on the power, make sure the cookware is on the ceramic plate with ingredients inside.
2. After plugging the plug into the socket, the LED indicator will show letter ‘L’, this means the
temperature of ceramic glass plate is lower than 50℃(150℉). If the temperature of ceramic glass
plate is higher than 50℃(150℉), the LED indicator will show letter ‘H’
3. To turn the power on, press the ON/OFF button once. The power light will turn a steady red and
heating will begin
4. To select the proper heat setting, press the REDUCE or INCREASE until the correct heat setting is
achieved.(defaults=1300W)
5. To select temperature setting, press the” TEMP” button (defaults=270 ) ,the temperature℉light will turn
a steady red ,and press the REDUCE or INCREASE until the correct temperature setting is achieved.
6. To select automatic timer setting, press the” TIMER” button (defaults =0mins),the timer light will turn a
steady red ,and press the REDUCE until the correct timer setting is achieved.
7. After cooking is completed, press the ON/OFF button again to turn off the unit.
8. After the cooking time reach 150 mins, the LED will show “EE” and sound, and then the unit will enter
the standby mode. Press the ON/OFF button to restart the unit.
Notice:
If using the unit in TEMP or HEAT Function, not setting the TIMER Function, but when the unit is used 150
mins, the LED display shows EE code and sound. The unit will stop automatically.
If using the unit in TEMP or HEAT Function 10 mins, and then set the TIMER, the max Timer is 140 mins.
During timer operation, you can change the duration at any time with the arrow keys.
NOTE: The power will completely shut off with 9 second if either (a) the wrong type of cookware is applied
or (b) no cookware is placed on the unit.
USABLE AND NONⅣ-USABLE UTENSILS:
Compatible Pans:
Steel or cast iron, enameled iron, stainless steel, flat-bottom pan/pots with diameter of 12 to26 cm.
Non- compatible Pans:
Heat-resistant glass, ceramic container, copper, aluminum pan/pots. Rounded-bottom pan/pots with
the base measuring less than 12cm.
ⅤCLEANING AND MAINTENANCE:
Clean after each use. Disconnect plug and wait until the unit has cooled down.
If the pots/pans are used without being cleaned, as this may result in discoloration or stains.
Do not use benzene, thinner, scrubbing brush or polishing powder to clean the induction cooker.
Wipe down the unit using a dish washing agent and a damp cloth
Use vacuum cleaner to suck up dirt from the air intake and exhaust vent.
Never run water over the unit (If water gets inside it may cause malfunction).
WARNING: any other servicing should be performed by an authorized service representative.
Error Code List
– If LED-display shows the error code, please reference to the solution as following.
Error Code Cause and Solution
“---“ on display and
sounded No suitable pot or no pot on the induction.
E1 Voltage is under 75V
E2 Voltage is over 145V
E3 IGBT in short circuit. The accessory and spare parts are damaged,
please contact the nearest authorized service facility for trouble
shooting, repair and adjustment.
E5 The temperature sensor underneath the cooking area is defective or
