Full Swing KIT User manual

QUICK START GUIDE
Version 2

CONTENTS
COMPATIBILITY
SAFETY & USER GUIDES
Carrying Case Launch Monitor
Charging Cable
Charger
• iPhone® (10 and higher), running iOS 14 and higher
• iPad® (7th generaon and higher), running iOS 14 and higher
• iPad® Air (3rd generaon and higher), running iOS 14 and higher
• iPad® Pro (all models), running iOS 14 and higher
• Apple Watch® (3 or higher), running watchOS 7 or higher
• Apple AirPods® or most any Bluetooth® headphones
For detailed safety informaon and the full user guide,
please scan the QR code below with your camera:

1. CHARGE IT UP
2. DOWNLOAD THE APP
• Remove the charger and cable from the inside pocket of the carrying case
• Gently open the rubber charging port cover on the le side of your Full Swing KIT, aach the
charging cable, then aach the charger to the wall
• Allow approximately 5 hours for a full charge
NOTE: You can pair and congure your KIT while in charging mode.
Please connue in this mode for steps 2 through 4.
To download and install the Full Swing app:
• Scan the QR Code below with your camera:
• Alternavely, search for Full Swing in the Apple App Store®
USB CHARGING PORT

3. PAIR & CONFIGURE
4. CHECK FOR UPDATES
5. POWER IT UP
Open the Full Swing app and follow the onscreen instrucons to:
• Create a Full Swing account or log in with an exisng account
• Pair your KIT with your mobile device
NOTE: Tap the Power buon to view your Device Name in the
upper le corner of the display
• Join your KIT to a Wi-Fi network (required for updates)
Your KIT will automacally download and install new updates while it is charging
and connected to Wi-Fi. For the best experience, please allow any updates
to nish before using your KIT.
NOTE: Do not power the unit on at this me. Updates will only install while
the unit is in charging mode.
Aer your KIT is completely charged and updated, it is ready to use.
• Press and hold the Power buon for 2 seconds to power the unit ON.
POWER ON/OFF
2S

6. SET IT UP
HELP?
7. START A SESSION
• Fully extend the rear leg of your KIT
• Place the unit 10 feet directly behind the ball
• Make sure the unit is level with the tee area and there are no obstrucons
Help Center and FAQ: kitsupport.fullswinggolf.com
Phone: [phone]
Email: [e-mail]
• Open the Full Swing app and tap Start Pracce Session
• Tap the Connect buon, then tap Join when prompted
• Select your Environment and Locaon (oponal), then tap Start Session
• Select a Club, then tap Use Club & Set Target
• Posion your KIT so that the white line is pointed at your target, and your
ball is within the tee area, then tap Set Target Line
10 FEET
FULLSWINGGOLF.COM