Fusion MS-BX402 User manual

User / Installation Manual
Marine Box Speaker
MS-BX402

2010 Version 1.0
RECORD YOUR PRODUCT DETAILS HERE:
MODEL NUMBER DATE OF PURCHASE
AFFIX RECEIPT HERE
Contents
List of Contents........................ Pg 4
Product Specifications .................. Pg 4
Line Drawings and Dimensions ........... Pg 5
Installation Guide....................... Pg 6
Trouble Shooting ....................... Pg 7

LINE DRAWINGS AND DIMENSIONS
004
CONTENTS 005 DIMENSIONS
FUSION Full Range Marine/Outdoor Box Speakers are carefully designed and manufactured specically
for marine use. FUSION Box Speakers feature a unique high tech bass/mid cone, a uid cooled titanium
dome tweeter, and are constructed to be water resistant and minimise magnetic interference.
These speakers have been thoroughly tested to ensure consistent and reliable performance is achieved
in the challenging marine environment.
LIST OF CONTENTS
• 2 x Speakers
• 2 x Connection Wire
• Mounting Hardware
• 2 x Mounting Bracket
• 4 x Mounting knobs
• Manual
• Warranty Card
• “FUSION Entertainment” Gel Badge
• 2 x FUSION Gel Badges, Green/Black
• 2 x FUSION Gel Badges, White/Black
• 2 x FUSION Gel Badges, Silver/Black
PRODUCT SPECIFICATIONS
Tweeter Type Titanium Dome
Max Power (watts) 120
Eciency (1W/1M) 87db
Frequency Response 90 – 22kHz
Impedance 4 ohms
197.0mm
180.0mm
201.0mm
142.1mm

PUBLISHED BY FUSION ELECTRONICS LIMITED:
© Copyright 2010 by FUSION Electronics Limited.
All rights reserved. Specications and design are subject to change
without notice.
YOU CAN HELP PROTECT THE ENVIRONMENT!
Please remember to respect the local regulations:
Hand in the non-working electrical equipment
to an appropriate waste disposal center.
006
INSTALLATION 007 TROUBLE SHOOTING
INSTALLATION GUIDE
1. Check mounting position for adequate space (see caution)
2. Place the mounting bracket in position, then mark and drill the mounting holes.
3. Place the mounting bracket and insert screws.
4. Connect the wires from the source unit to the box speaker ensuring the correct polarity is
observed.
5. Attach the box speaker to the bracket using the mounting knobs supplied
6. Adjust the angle of the speaker to the preferred position before tightening the mounting knobs
CAUTION:For speaker mounting restrictions, please refer to manufacturers recommendations for any
related navigational equipment.
Installation Tips
Any speaker will only perform to its best capabilities, when correctly placed in the listening area.
FUSION Engineers recognise that unlike a home or motor vehicle installation, there are an extremely
wide range of marine environments where speakers may be placed. FUSION Full Range Marine Speakers
are optimised to perform in the widest possible range of mounting locations, but a little thought and
care with placement will always be rewarded with better sound.
• High frequencies are directional. Placing the speakers low down in the boat will lose some of this
information.
• Speakers should be placed to simulate a “sound stage”, by being placed where you are able to hear
both speakers in a stereo situation.
TROUBLE SHOOTING
Before you contact your FUSION dealer or service centre, FUSION requires that you do some simple
trouble shooting to help diagnose the problem.
Problem Solution
No sound Check all connections from the source unit amplier to
the speaker terminals are connected correctly
System lacks in bass Check the connections from the source unit/
amplier to the speaker. Ensure the positive wire from
the source is connected to the positive of the speaker.
System lacks in high frequencies Check polarity
Check the bass / treble control settings on the source
unit
Distorted sound Check all wiring
Check that it is not the surrounding panels of the craft
rattling. Check connections from the source to the
speaker.

Specications and design are subject to change without notice.