Futtura CL2P3 User manual

1Cross+3dot Cross Line Laser

1
OPERATING THE UNIT
Pendulum Lock
This laser level is a precision instrument and should be treated with care. When
not in use, the pendulum should always be in the Off position (Figure 1). Locking
the pendulum allows the Cross Line Laser to better withstand vibration and
trauma incurred during transportation or if the unit is dropped.
Locked Line Angle
In the locked line angel position (figure 2), the pendulum is in the locked position
and will not automatically level. When in the locked line position, both two laser
lines will be on and flash slowly.
Figure 1
Figure 2

2
Automatic Leveling
When the pendulum is unlocked (figure 3), the pendulum is free to automatically
level, In order for the Cross Line Laser to automatically level, the base of the unit
needs to be within 4°of level.
When the pendulum is unlocked and the Cross Line Laser is within 4°of level, the
unit will be in automatic leveling range, in this situation only the BATTERY LED
light will be on.
Should the base of the unit be outside the 4°leveling range the laser beam will
start with a quick flash.
Low Battery Alarm:
The Red battery LED will be on when the laser is turned on. It will keep flashing
slowly when the working voltage of laser is below 4.4V. At this situation the
batteries are required to be replaced. Laser will shut off itself when the voltage is
below 3.9V.
Figure 3

3
Keypad Panel:
Pulse on/off
Pulse LED
Plumb Up beam
Battery/
Low Voltage LED
Line options

4
What is included:
1. Instrument
2. Laser Plate
3. Wall mount bracket
4. User manual
5. Alkaline batteries

5
SPECIFICATION:
Accuracy of H&V line
± 2mm@5m
Accuracy of Plumb up/down beams
± 2mm@5m
Leveling Range
4°
Working Range/With Detector
15m/60m with detector
Tripod Thread
1/4" & 5/8”
Laser Type
635 nm, laser class II
Operating Temperature
-10℃to 50℃
Storage Temperature
-20℃to 60℃
Dimension
123 x 65 x 99/cm3
Continuous Working Time
≥8hour